1 / 19

Configuration Design part 2

Configuration Design part 2. Wing Placement. HIGH WING: PROS. 1. Quick loading and unloading. C-5, C-17 Loading and unloading through nose / tail doors: important to have low floor level.

tarak
Download Presentation

Configuration Design part 2

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Configuration Design part 2 Wing Placement

  2. HIGH WING: PROS 1. Quick loading and unloading.C-5, C-17 • Loading and unloading through nose / tail doors: important to have low floor level. • Low-wing ac: main deck floor is 16-17 ft (5 m) above the apron because the wing carry-through structure passes below the floor. Necessary to have special loading and boarding equipment. 2. Best for braced-wing monoplanes.Cessna • Struts cause little interference when attached to the lower side of the wing. • Lighter struts because they are stressed in tension. 3. The wing is generally lighter.

  3. C-17

  4. Cessna 152

  5. HIGH WING: PROS 4. The nose-wheel gear is shorter and lighter. 5. Best for STOL QSRA • Close proximity of the wing to the ground during TO and LNG may cause pronounced undesirable ground effects. • Required ground clearance for large, fully deflected TE flaps and large props would entail a very tall and heavy LG in a low wing configuration. 6. Safer. • Damage and fire risk is limited during a forced LNG. 7. Less Ground Effect in CTOL Shorts 330 • Smaller LNG distance. 8. Best for amphibians Boeing 314-A • Keeps engines away from H2O.

  6. Quiet Short Research Aircraft

  7. Shorts 330

  8. Boeing 314-A

  9. HIGH WING: CONS 1. Problem w. the retraction of the mainLG. • In small, high-wing propeller ac, main LG can be retracted into engine nacelles (Fokker F-27) or in tail booms (Hawker Siddeley Argosy). In large ac, however, this would make the LG too tall and heavy. • A solution for large ac: fuselage-mounted LG. • Problem 1: strengthening of the fuselage structure required for the transmission of the LNG impact results in W increase. • Problem 2: with a fuselage mounted main LG the track may not be sufficiently wide. 2. No ground effect in CTOL. • Increased TO distance.

  10. Fokker F-27

  11. Hawker Siddeley HS.660 Argosy

  12. HIGH WING: CONS 3. No room for underfloor cargo. • Fuselage section below the floor is flattened to reduce LG height + keep the floor low (4-4.5 ft = 1.2-1.4 m). • Solution: longer cargo hold in cabin. • Problem 1: longer fuselage. • Problem 2: large cg travel. 4. Unsafe • Fuselage will sink when ac is forced down on water. Provisions must be made for escape through the cabin roof. 5. Not good for highly maneuverable ac. • Too stable in roll.

  13. HIGH WING: CONS 6. ~ 20% more SV than a low-wing configuration. 7. OEW is generally higher. 8. Structural design is generally more complicated.

  14. MID WING: PROS • Min D in high-speed flight. (fighters, trainers) • Surfaces at wing / fuselage junction meet at 900 angles; interference between BLs at low a is minimized. • Fuselage section at the location where the wing is mounted is roughly cylindrical; divergence of airflow over wing root is minimized. • Best maneuverability. • Wing can be continuous through the fuselage • transfer of loads from the wing can take place via almost solid “bulkheads”, to which each wing-half is attached.

  15. F-18 Hornet & T-37

  16. MID WING: CONS • Reduced internal useful fuselage volume. • That is the reason why mid-wing configurations are not adopted for transports.

  17. LOW WING: PROS • Efficient use of fuselage under-floor space. • Large tail angle allows for optimum rotation during TO (especially for stretched versions). • Easy retraction of main LG between wing spars. • Safer. • A low wing and possibly the engines attached to it form a large energy absorption mass during a forced LND. • Favorable ground effects. • Decreased TO distance. • AC lands itself; little or no elevator movement required to flare out because L increase results in nose-up pitching M. • Better maneuverability than a high wing.

  18. LOW WING: CONS • Unsafe. • Potential fire hazard during forced LND when wing and engines hit the ground. • Unfavorable ground effects. • AC floats during LND; longer LND distance. • Greater elevator deflection required for TO rotation and LND flare out. • Decreased downwash on the tail results in nose down pitching M. • Longer LGespecially on swept back wings, to provide tip clearance during TO rotation.

More Related