1 / 8

INPUT SENSORS

INPUT SENSORS. OXYGEN SENSORS. 02 SENSOR DESIGN. THREADED INTO EXHAUST SYSTEM ELEMENT INSIDE STEEL SHELL ELEMENT MADE FROM ZIRCONIA COVER OVER TOP PORTION AND ALLOWS OXYGEN TO OUTER PORTION OF ELEMENT. CLASS PAGE 168, FIG 8-26. DESIGN. ONE WIRE TWO WIRE THREE WIRE FOUR WIRE

steve
Download Presentation

INPUT SENSORS

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. INPUT SENSORS OXYGEN SENSORS

  2. 02 SENSOR DESIGN • THREADED INTO EXHAUST SYSTEM • ELEMENT INSIDE STEEL SHELL • ELEMENT MADE FROM ZIRCONIA • COVER OVER TOP PORTION AND ALLOWS OXYGEN TO OUTER PORTION OF ELEMENT CLASS PAGE 168, FIG 8-26

  3. DESIGN • ONE WIRE • TWO WIRE • THREE WIRE • FOUR WIRE • SOME HAVE INTERNAL HEATERS

  4. OPERATION • PRODUCES IT’S OWN VOLTAGE • O2 ON BOTH SIDES OF ELEMENT, PRODUCES A LOW VOLTAGE • DIFFERENT AMOUNTS OF OXYGEN ON BOTH SIDE OF ELEMENT, PRODUCES A HIGH VOLTAGE • VOLTAGE CHANGES OCCUR IN MILLISECONDS • CROSS COUNTS

  5. CAUTIONS • IF LEAD COATS THE ELEMENT, GENERALLY WILL DESTROY SENSOR • IF ANTI-FREEZE OR RTV SILICONE IS USED, WILL RUIN 02 SENSOR • MUST USE A DIGITAL METER TO TEST • TIGHTENING - USE ANTI-SEIZE

  6. TYPE OF 02 SENSORS • ZIRCONIA - PRODUCES IT’S OWN VOLTAGE • TITANIA - MODIFIES A BIAS VOLTAGE SENT TO IT FROM THE POWERTRAIN CONTROL MODULE • (USUALLY ABOUT .45 VOLTS)

  7. TESTING 02 SENSORS • 02 SENSOR MUST BE AT NORMAL OPERATING TEMP. (600 DEGREES) • DEDICATED SENSOR GROUND • AVOID PIERCING INSULATION (IF MUST, THAN RESEAL HOLE) • DON’T USE ANALOG METER • USE DVOM LAB PAGE 140

  8. TESTING • SCANNER • USE ENGINE ANALYZER LAB SCOPE • USE PORTABLE LAB SCOPE • PROPANE TORCH • USE YOUR BODY TO TRICK PCM • HEATER DIAGNOSIS

More Related