1 / 12

Arizona State University Autonomous UAV Project

Justin DeStories Aircraft Design. Arizona State University Autonomous UAV Project. Objective/Requirements. The UAV team at Arizona State University is designing, optimizing, and building an autonomous Unmanned Aerial Vehicle (UAV) to compete in a 2010 UAV aerial imaging contest. 

skule
Download Presentation

Arizona State University Autonomous UAV Project

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Justin DeStories Aircraft Design Arizona State UniversityAutonomous UAV Project

  2. Objective/Requirements • The UAV team at Arizona State University is designing, optimizing, and building an autonomous Unmanned Aerial Vehicle (UAV) to compete in a 2010 UAV aerial imaging contest.  • The objectives of the contest are: (1) to fly an UAV via autopilot non-stop for 20-40 minutes in a square search area of 1 square miles, and (2) use onboard/remote human detectors to locate and identify targets marked by colored alphabets Website: http://pma263webdev.bowheadsupport.com/studentcomp2010/default.html Additional contest rules: (1) fly between 100 and 750 feet above ground, (2) fly over way points (GPS), (3) some targets are along route/some are not, and (4) better performance = higher score

  3. Wing Design Flow Chart

  4. Wing Design Analysis (cont) • Relatively good at floating. • But not as fast due to the thicker airfoil (11.7%). • Is flat on the lower surface from 30% of the chord back. • It gives reasonable overall performance in respect of its lift to drag ratio. • Has gentle stall characteristics.

  5. Preliminary Weight Budget • Researched Weights of components that were going to be used for building operating the aircraft.

  6. Wing Design Analysis • From research, choose Wing Loading and used it to determine the initial size of the aircraft. • For ease of construction and stability considerations the Wing Loading for our aircraft is

  7. Wing Design Analysis (cont) • From Wing Loading and Chord length, all other wing parameters were calculated • Wing Planform Area (S) • Wing Span (b) • Aspect Ratio

  8. Wing Design Considerations • Ease of Construction • Ease of Maintenance • Transportability • 3 Separate Wing Sections 1 2 3

  9. Wing Construction

  10. Fuselage Design and Fabrication • Designed for ample room of equipment. • Batteries • Autopilot System • Flight Pack/Reciever • Antennas • Mini Computer (future)

  11. Next Up • Ground/flight testing • Testing of the Autopilot • Camera Gimbal Setup Any Question?

More Related