Wiring a ceiling fan is easy and it adds to the attractiveness of your home. The electrical wiring is simple because the fan has internal wiring that connects to the fan motor and the light with two easy steps.
Wiring a ceiling fan is easy and it adds to the attractiveness of your home. The electrical wiring is simple because the fan has internal wiring that connects to the fan motor and the light with two easy steps. Solar Power Advantages and Disadvantages
Putting a ceiling fan up is a great home improvement project that nearly anyone can accomplish over a weekend. It makes your home more comfortable, and adds to the resale value if you choose to move later on.Before getting into a ceiling fan installation, however, there are a number of things you should consider. These considerations range from electrical safety to aesthetics to logistics, even to budget.First, measure the room. For a typical room of about 12 by 10, most of the commercially available ceiling fans should work. (these, confusingly enough, are measured by the span of the entire blade assembly, not the length of a blade). When in doubt, go for larger spans.
Now, having bought the fan and made sure it worked with your room, comes the assembly process. You should be able to plug the ceiling fan into the same wiring runs that power your overhead light; it's worth it to take the time to find those runs, make sure that they extend to where you want the fan mounted and then turn off the breaker. Then, double check that you turned off the right breaker.The first step, once this is done, is to set the mounting pipe into your ceiling and run the wires through it and connect them up. Then, screw the motor unit for the fan onto the pipe, and seal up the case. Before putting on the blades, turn the breaker on and try turning the motor on; you should see it running.
If you don't, turn the breaker off, and double check; the likely candidate is having mis-wired the ground wire.Once you've got the fan working, it's time to put the blades in. EZ Battery Reconditioning ReviewYou'll want to mount them to the brackets and tighten them in carefully; make sure you have them counter-weighted properly, especially on fans with an odd number of blades.Check the breaker again, and turn them on; you'll want to keep an eye on the fan for a bit; you're looking for signs of an unbalanced load, which will be a vibration or shimmy in the blades. Turn the fan off when you find it, and selectively loosen and tighten screws until the shimmy or wobble goes away. http://quantumvisionsystemreview.org/ez-battery-reconditioning-program-review/