DRIVE DESIGN FOR VBELTS
To obtain the best performance from VBelts, it is necessary to design the drive correctly. The procedure for the same is as follows.
STEP 1 Calculate Speed Ratio (SR)
Speed Ratio (S R ) 
= 
r.p.m of Faster Shaft (R) 


r.p.m of Slower Shaft (r) 
STEP 2 Select Service Factor (K)
Service factor is obtained from table Service Factor
STEP 3 Calculate Design Power (Pd)
Design Power (P d ) = Power (P) x Service factor (K)
STEP 4 Select Belt Cross Section
Belt cross section is obtained from the Belt Cross Section Selection Chart. When the point of intersection falls on or near the dividing line, feasibility of both cross sections should be checked.
STEP 5 Select Pulley Pitch Diameters
Refer to Recommended Pulley Diameters for selecting pulley pitch diameters. Try to avoid use of nonstandard pulleys but in some cases, it is necessary if the exact ratios are not covered by standard pulleys.
STEP 6 Calculate Belt Pitch Length (Lp) and Center Distance (C)
Belt Pitch Length (Lp) = 2C + 1.57 (D + d) + 
(Dd)^2 

4C 
Where, D & d are pitch diameters of larger & smaller pulleys respectively.
Choose the nearest available belt length from VBelts Production Range If there is a space constraint or center distance limitation, use the same calculated length. If so, exact centre distance calculation is not required again.
Calculate the exact center distance by the formula
C=A+ v A 2 B
STEP 7 Determine Power Rating (P)
Refer to Power Rating Tables from for different belt sections.
Power rating per belt (P) = rated power + Additional power for speed ratio
STEP 8 Find Arc of Contact Correction Factor (Fc) & Belt Pitch Length Correction
Factor (Fd)
Refer for Arc of Contact Correction factor & Belt Pitch Length Correction factor respectively.
STEP 9 Find Number of Belts (N)
Number of Belts (N) 
= 
Pd 


P x Fc x Fd 
If the number of belts comes in a fraction, use next whole number.
STEP 10 SUMMARY
i) Smaller & larger pulley pitch diameters & number of grooves obtained.
ii) Number of belts along with size & section obtained.
