1 / 8

MAGGEX

MAGGEX. Post-Flight Analysis. Magnetic Field Overview. B=B m +B c +B d B m : Earth’s fluid conducting outer core 95% of measured field B c : Magnetized rocks in crust (~.02 mG) B d : Currents induced in magnetosphere by solar and extraterrestrial activity (~.250mG)

saskia
Download Presentation

MAGGEX

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. MAGGEX Post-Flight Analysis

  2. Magnetic Field Overview • B=Bm+Bc+Bd • Bm: Earth’s fluid conducting outer core • 95% of measured field • Bc : Magnetized rocks in crust (~.02 mG) • Bd : Currents induced in magnetosphere by solar and extraterrestrial activity (~.250mG) • Expect to see change from 492 mG at ground level to 484 mG at 100,000ft

  3. Issues • Instability of measurement during flight • Due to movement of payload • No data collected past 28 minutes of flight, ~30,000 ft. • Unresolved • Low-pass filter applied, overall downward trend apparent, but not enough data

  4. Induced Payload Instability

  5. Internal Temperature

  6. Potential Sources of Failure • Loss of power? • RTC never stopped, power still on when payload recovered • EEPROM Problem? • Post mortem analysis shows full data can be written without error • Temperature Problem? • At 30,000, entering Stratosphere • In tests, payload survived to -2 C, internal temp showed payload electronics above 10 C • Mechanical Failure? • Switch lodged between on and off state, halting software but keeping low power? • Chip software was never reset • Soldering error? • During cold, joint dislodged, at some later point, inadvertently knocked back into place?

More Related