1 / 20

MarcoPolo-R

MarcoPolo-R. Mission and Spacecraft Design. Lisa Peacocke – 19 th June 2013 IPPW 2013, San Jose, USA. MarcoPolo-R Mission. ESA Cosmic Vison M-class candidate Aim: To return a sample from a primitive near-Earth asteroid Currently Phase A, down-selection in Feb 2014

Download Presentation

MarcoPolo-R

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. MarcoPolo-R Mission and Spacecraft Design Lisa Peacocke – 19th June 2013 IPPW 2013, San Jose, USA

  2. MarcoPolo-R Mission • ESA Cosmic Vison M-class candidate • Aim: To return a sample from a primitive near-Earth asteroid • Currently Phase A, down-selection in Feb 2014 • Target is primitive asteroid 2008 EV5 • MarcoPolo-R Assessment Study and CCN • Demonstrate technical and programmatic feasibility of the mission • Achieve a cost-effective and consolidated mission design • Astrium team kicked off in February 2012 • Team of 18 engineers currently working on the study

  3. Mission Design • Launch on Soyuz-Fregat to 2008 EV5 • Launch years 2022, 2023, 2024 • All outward trajectories require an Earth GAM • Mission durations 4.5-6.5 years • 2008 EV5 DeltaV’s relatively low • Plasma propulsion architecture becomes feasible • Reduced return velocities for Earth re-entry • Other benefits of 2008 EV5 • Smaller asteroid => less surface area to map • Less extreme orbit with more consistent Sun distance • Lower mass asteroid => lower gravity environment 1996 FG3 Primary and Secondary 2008 EV5

  4. Science Operations • Operations phases give ~140 GB data • 8 hours data downlink per day is feasible • ESA’s 35 m ground stations

  5. Spacecraft Design

  6. Spacecraft Design • Mechanical • Solar Orbiter derived structure, modifications to support plasma thrusters • Propulsion • Three Snecma PPS1350 plasma thrusters (1.5 kW) with pointing mechanisms and PPUs – SMART 1 • Two Xenon tanks and a high pressure regulator – BepiColombo MTM • Aeolus derived monopropellant system with 20N thrusters and hydrazine tanks • Thermal • ‘Standard’ design with heaters and MLI, detailed analysis ongoing • One panel with embedded heat pipes to aid PPU heat dissipation • AOCS • Off-the-shelf European IMU, star tracker, reaction wheels and sun sensors • Electrical • Two rotating solar array wings (7.5 m2 each) with drive mechanism – Sentinel 1 & 2 • Lithium-ion battery and TerraSAR-X2-based 50V PCDU • Mars Express 1.6 m high gain antenna; MGA and LGAs with 80 W RF TWTA and deep space transponder – BepiColombo/Solar Orbiter/LISA Pathfinder • Gaia-based on-board computer with mass memory, and Solar Orbiter RIU

  7. Spacecraft Design

  8. Payload Accommodation • All instruments mounted on same structure panel • Facilitates integration and mutual alignment • Accommodated inside spacecraft with views through cutouts

  9. Key Technologies • Proximity GNC • Visual navigation uses Wide Angle Camera based on NPAL development and a Radar Altimeter • Simulations performed for descent/touchdown • Sample Acquisition, Transfer and Containment • Rotary brush sampling mechanism developed and tested • Touchdown damping from boom back-driven motor • Minimal forces at 10 cm/s • Earth Re-entry Capsule • Hard landing, no parachute or beacons/battery • Hayabusa-shape aeroshell

  10. Proximity GNC/AOCS

  11. Touchdown Dynamics

  12. Sampling and Transfer

  13. Sampling Mechanism Early Testing

  14. Sampling Mechanism

  15. Earth Re-entry Capsule • Main requirements • Maximum entry velocity = 12 km/s • Maximum heat flux = 15 MW/m2 • Maximum total pressure at stagnation point = 80 kPa • Fully passive, no parachute – cost and MSR demonstration • Ensure impact loads to sample are less than 800 g • No beacon or battery on board • Land at Woomera, Australia • Entry flight path angle of -10.8 degrees selected • Based on entry dispersion and appropriate landing ellipse • Hayabusaaeroshape selected • Stable and meets g-load, aerothermo requirements • θc= 45 deg, RN/D = 0.5

  16. Earth Re-entry Capsule • Design Properties • Diameter = 0.880 m, Mass = 45.6 kg, Centring = 28.75% D (Max ~33% D) • TPS: 56 mm ASTERM on frontshield (low density carbon phenolic, 280 kg/m3) • 11 mm NorcoatLiége on backcover (low density cork phenolic, 470 kg/m3) • 170 mm Aluminium foam crushable material, PU foam surrounds container

  17. Earth Re-entry Capsule • 2 rpm min spin-up

  18. Earth Re-entry Capsule • Landing ellipse is 68 km along longitudinal axis

  19. Conclusions • Phase A study finishing at the end of July • Preliminary Requirements Review in Oct/Nov • Selection will occur in February 2014 • Astrium’s mission & spacecraft design is feasible • Key technologies are well into development • Extensive unit re-use or modification • Keeps development costs to a minimum, reduces cost risk • MarcoPolo-R is a very promising M-class mission candidate • New target has simplified engineering & design significantly • Serendipitous short mission trajectories – right time for asteroid sample return

  20. Questions? MarcoPolo-R Team: Steve Kemble, Héloise Scheer, Jean-Marc Bouilly, Antoine Freycon, Steve Eckersley, Brian O’Sullivan, Jaime Reed, Martin Garland, Mark Watt, Marc Chapuy, Kev Tomkins, Howard Gray, Bill Bentall, Andrew Davies, Chris Chetwood, Andy Quinn, Alex Elliott, Mark Bonnar, David Agnolon, Remy Chalex, Jens Romstedt

More Related