1 / 40

TRENCH OPERATIONS

TRENCH OPERATIONS. For safety is not a gadget but a state of mind.  ~Eleanor Everet. Objectives . Governing Standards Anatomy of a Trench Soil Physics First arriving units actions/ Scene management Equipment Familiarization Type of Trench Collapses Techniques for Protection.

rae
Download Presentation

TRENCH OPERATIONS

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. TRENCH OPERATIONS For safety is not a gadget but a state of mind.  ~Eleanor Everet

  2. Objectives • Governing Standards • Anatomy of a Trench • Soil Physics • First arriving units actions/ Scene management • Equipment Familiarization • Type of Trench Collapses • Techniques for Protection

  3. OSHA CFR 1926 Subpart P, Excavation: • Important to rescuers for several reasons • First the data and information will give you the information from which you can decide the protective systems. • Secondly, knowledge of the standard, its requirements, protective systems, and soil classifications will qualify the user as a “Competent Person”.

  4. General requirements All trenches must be protected before entries except: • Those made entirely of stable rock. • Those less than five feet in depth, including the height of the spoil pile must be protected. • Protection: • Anything more than five feet in depth, including the height of the spoil pile must be protected. • Spoil Pile: • Must have two-foot set back for the lip. • Egress: • Trenches four feet or greater in depth must have a means of egress every twenty-five feet “Ladders”. • Atmospheric: • Trenches four feet or greater in depth must be tested before entry.

  5. Definitions • A “trench”, means a narrow excavation (in relation to its length) made below the surface of the ground. In general, the depth is greater than the width, but the width measured at the bottom is not greater than 15 feet. WIDTH DEPTH

  6. ”Excavation”, includes a trench It means any man made cut, cavity, trench, or depression in an earth surface formed by the earths removal. Again, in practical terms, when a hole is more than 15 feet wide at its base, it is called specifically an excavation. Overall, an excavation is wider than it is deep.

  7. Competent Person • One who can identify existing or predictable hazards in the surrounding that are unsanitary, hazardous, or dangerous to employees. Also has authorization by the nature of their position to prompt corrective measures to eliminate them. The person shall be knowledgeable in the requirement of this part.

  8. Anatomy

  9. How Heavy is Dirt? • Physical forces associated with collapse: • Dirt has volume that has mass and weight • One cubic foot of dirt weights between 85 and 125 pounds per cubic foot.

  10. Weight of one cubic yard of soil Weight of a Volkswagen 2,785 Pounds 2,700 Pounds

  11. Soil Physics • Compounding the effects of gravity is hydrostatic pressure • Add the weight of water and rock, a cubic foot of dirt can be as much as 125 pounds per cu/ft

  12. A six foot trench: • at the four foot level has approximately 400 pounds vertical pressure • Lateral forces could be expected to be 132 pounds • Distribution of lateral pressure occurs on about a 45 degree angle from the bottom

  13. Accidents without cave-ins • Most emergencies in trenches deal with something other than a collapse • Most of the work is done after the trench has been dug • In these cases don’t be lulled to sleep by a protected trench • Approach identically as an open trench

  14. Hazards Present?

  15. First Arrival • Apparatus spotting • Spot at least 100 ft from location • Create Exclusion Zones (on next slide) • Size-up – accurate address of location, call for help • Secure RP, job foreman, or witness to accident • Safety 360 Review – approach trench from the end, Secondary size-up • Rescue or Recovery mode • Assess potential hazards to rescuers (Atmospheric, water,Trench etc) • Make The Trench Lip Safe – ground pads/ Ladder bridges • Shielding of patient – with material on site, plywood, backboard • Air monitoring – Bottom at patient, middle and top of trench • Apparatus Base Area with manager. location?

  16. Trench Scene Management

  17. Ground pads • For distribution of weight on trench edge

  18. Ladder Bridge

  19. Review of Monitoring Values

  20. Equipment Familiarization • Strongbacks/Uprights = Shoring Panels • Yates Spec Pack • Waler • Palm nailer • Airshore • Speedshore

  21. Types of Collapses Spoil pile slide • Excavated earth too close to the lip • Heavy rain increasing wt of pile

  22. Slough In / Lip slide Slough failure • The loss of part of the trench wall

  23. Sheer Wall Shear wall collapse • section of soil that loses it’s ability to stand

  24. Toe Failure Toe failure • Slough that occurs at the bottom • Found in location of fill dirt

  25. Bell Pier Condition Bell pier condition • Long term toe failure on both sides

  26. Rotational Failure Rotational failure • Scoop shaped collapse that starts at the lip and transmits itself to the trench walls

  27. Wedge Failure Wedge failure • Occurs with intersecting trenches, T or L Trench • Angled section of earth falling from the corner of an intersecting trench

  28. TECHNIQUES FOR TRENCH PROTECTION

  29. TECHNIQUES FOR TRENCH PROTECTION

  30. TECHNIQUES FOR TRENCH PROTECTION • Ops operating within trench • Straight wall trench procedures: • Set middle set of panels as directly over the victim as possible • For Pneumatic Struts: • Set middle shore • Set top shore • Set bottom shore

  31. Outside Waler • Uses outside walers to span opening • Outside waler procedures: • Place pickets to tie walers • Place and tie off bottom of Waler • Place and tie off top of Waler • Set middle set of panels as directly over victim as possible

  32. Inside Waler • Inside walers are used to span a set of panels for the purpose of creating an open space

  33. The intersecting “T” trench is a very unstable trench because not only is one wall exposed, but a section has been cut that intersects the other wall.

  34. The “L” trench can be describe as two trenches that intersect at there ends

  35. Deep trenches are those trenches over 10 feet but not more than 20 feet

  36. Pier-hole

  37. Trench Environments

More Related