1 / 14

Planometric Views (room corner)

Planometric Views (room corner). Graphic Communication. Department of Technological Education. Department of Technological Education. GC Credit Paper – 2002 – Question 3. An Elevation and Plan of a room layout are shown.

petra-ingram
Download Presentation

Planometric Views (room corner)

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Planometric Views (room corner) Graphic Communication Department of Technological Education

  2. Department of Technological Education GC Credit Paper – 2002 – Question 3 • An Elevation and Plan of a room layout are shown. • Using the given sizes and start position, draw a Planometric view of the room layout (include the back wall, side wall and the floor area) • Do not show hidden detail (DA10)

  3. Department of Technological Education GC Credit Paper – 2002 – Question 3 • Start by drawing the Plan at the correct angle. • In this case the start point is given at ceiling level so it is necessary to find out where the floor area starts. Draw the positions of any furniture etc. on the floor area.

  4. Department of Technological Education GC Credit Paper – 2002 – Question 3 • Draw the positions of any walls required. Include any doors and windows on the walls.

  5. Department of Technological Education GC Credit Paper – 2002 – Question 3 • Add any furniture to the Planometric view.

  6. Department of Technological Education GC Credit Paper – 2002 – Question 3 • Add any furniture to the Planometric view.

  7. Department of Technological Education GC Credit Paper – 2002 – Question 3 • To finish the drawing darken the outlines on the drawing. • Remember that the question asks that hidden edges are not shown so some of the lines will be left as construction lines.

  8. Department of Technological Education GC Credit Paper – 2002 – Question 3 • This drawing was awarded 10 Drawing Ability marks. • The following slides show the official marking scheme for this drawing.

  9. Department of Technological Education GC Credit Paper – 2002 – Question 3The Marking Scheme – box a • Draw 2 walls and a floor • 2 marks • If walls only drawn then 1 mark

  10. Department of Technological Education GC Credit Paper – 2002 – Question 3The Marking Scheme – box b • Draw door (size and position) • 2 marks

  11. Department of Technological Education GC Credit Paper – 2002 – Question 3The Marking Scheme – box c • Draw picture (size and position) • 1 mark

  12. Department of Technological Education GC Credit Paper – 2002 – Question 3The Marking Scheme – box d • Draw bookcase (size and position) • 2 marks

  13. Department of Technological Education GC Credit Paper – 2002 – Question 3The Marking Scheme – box e • Draw sofa (size and position) • 2 marks

  14. Department of Technological Education GC Credit Paper – 2002 – Question 3The Marking Scheme – box f • Draw carpet (size and position) • 1 mark

More Related