1 / 13

Installation Guide

www.freewater.com.au. Installation Guide. *This information is provided as a guide only. All supplied instructions should be pre read prior to commencing installation. Index. Slide 3 … Freewater ® Components List Slide 4 … Joining Tanks

ling
Download Presentation

Installation Guide

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. www.freewater.com.au Installation Guide *This information is provided as a guide only. All supplied instructions should be pre read prior to commencing installation

  2. Index Slide 3 … Freewater®Components List Slide 4 … Joining Tanks Slide 5 … Fitting Connector Hose Slide 6 … Laying Rails Slide 7/8 … Strapping Slide 9 … Tank Mounting Slide 10/11 …Tap Assembly and Location Slide 12 … Tighten Hose Clamps Slide 13 … Freewater®Instruction Download

  3. Freewater®Components List • Add on Tank(s) • 1 Freewater® Tank • 1 Mounting Kit • Support Rail- lengths as • required • 1 Connector Hose Kit • First Tank • 1 Freewater® Tank • 1 Mounting Kit • 38x25 Support Rail • @ 5m (6x800mm) • 1 Tap Assembly

  4. Joining Tanks Together Using a 65-75mm Hole Saw, drill lower connection points of each tank to be joined

  5. Fit Food Grade Rubber Connector Hose between tanks and tighten clamps each side

  6. Lay Rails Across Tank Single Tank Multiple Tanks

  7. Strapping Slide strapping over back rail and fold at front, top over bottom

  8. Secure in position and Tek Screw in place

  9. Mounting Lift assembled Freewater®tanks into position and secure back rails using supplied fixings

  10. Freewater®Tap Assembly Use either a 22mm (7/8”) Spade Blade or Hole Saw Drill hole to suit Personal location on any flat surface, not on seam or near edges

  11. 2. Grip bolt (supplied) with pliers/ multigrips. Push internal sleeve into barb, locating bolt head in tap housing 1. Insert Barbed end into 22mm hole 3. Hold bolt steady and rotate tap housing clockwise to tighten, ensuring both rubber “O” rings remain in their grooves

  12. Tighten Hose Clamps As minor settling of the rubber connector hose may occur, further tightening of the clamps may be required at the end of the install process

  13. Freewater®Instructions Go To www.freewater.com.au About Us Download Freewater Instructions PDF

More Related