Cisco 300-360 dumps – Authentic 300-360 dumps - Dumpsforsure.com

1. Cisco Exam 300-360 Designing Cisco Wireless Enterprise Networks Version: Demo [ Total Questions: 10 ]

2. Cisco 300-360 : Braindumps Questions Question No : 1 Which two types of information must be included in the installation inventory portion of the post-installation report? (Choose two.) A. all AP, controller, and MSE administrator credentials B. the names, locations, IP addresses, MAC addresses, etc. for every AP, controller, and MSE in the WLAN C. a layout of the rack that the equipment is installed D. results of the coverage audit performed with the site survey mapping tool E. the number and type of all WLAN clients and tags Answer: A,B Question No : 2 An engineer is determining powering requirements for a P2P wireless link using Cisco Aironet 1572EC access points. Which power method is valid for the access point? A. 802.3af Power over Ethernet B. Power over Cable C. Cisco Inline Power D. 802.3at Power over Ethernet Answer: B Question No : 3 You deploy a wireless network for a common area located outside of a student dorm by using patch antennas. Students report weak signals in specific locations of the coverage areA. Which option is a possible cause of the issue? A. neighboring buildings B. vehicles C. trees D. Bluetooth interference 100% Success with Our Dumps 2

3. Cisco 300-360 : Braindumps Questions Answer: D Question No : 4 A wireless engineer is configuring VoWLAN on a WLC. Which configuration should be implemented on the router or switch that is connected to the WLC? A. The interface on the switch or router should trust the CoS settings of the WLC. B. The interface on the WLC should mark all packets as EF. C. The interface on the switch or router should strip all CoS markings on the IEEE 802.11 header. D. The interface must be configured as a Layer 3 interface. Answer: A Explanation: We recommend that the QoS policy on the router/switch interfaces connected to the WLC be set to trust the CoS settings of the WLC. This means that the wired network responds to the CoS values controlled by the QoS policy set on the WLC. The WLC does not enforce any policy that changes the WLAN client DSCP values. The WLC policy effects will only be seen in the CoS values associated with the WLAN client traffic. If the routers and switches connecting to the WLC are set to trust DSCP, then a DSCP policy must be created and maintained on those router and switch interfaces--in addition to the policies applied on the WLC. For more information on WLAN QoS and traffic classification, refer to the Chapter 3, "Voice over WLAN Radio Frequency Design”. https://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Mobility/vowlan/41dg/vowlan41 dg-book/ vowlan_ch8.html Question No : 5 Which type of information should be included in an installation report? A. A complete characterization of the external WLAN environment. 100% Success with Our Dumps 3

4. Cisco 300-360 : Braindumps Questions B. The exact number of users the WLAN will support. C. Soft copies of configuration for switches, routers, controllers, and location appliances. D. A detailed description of the WLAN environment during the post-installation testing, for example, number of people present, furniture, no furniture, and sources of interference present. Answer: C Question No : 6 Which two best practices should be considered when a customer wants to purchase and implement Voice over Wireless for Cisco 7925 IP Phones? (Choose two.) A. Enable lower data rates for 2.4-GHz data WLAN and higher data rates for phones. B. Use a separate Cisco Wireless Lan Controller. C. Enable 802.1x and Cisco Centralized Key Management for phone authentication. D. Use dedicated Access Points only for Voice over Wireless. E. Set data for 2.4 GHz and voice for 5 GHz using separate SSIDs. Answer: C,E Question No : 7 When conducting a wireless survey at a customer facility, signal attenuation in an area that is surrounded by thick glass walls is noted as 2dB. When configuring Cisco Prime Infrastructure, which obstacle should be placed in a map editor to represent the impact the glass wall will have on the RF signal in the facility? A. heavy door B. thick wall C. glass D. light wall Answer: D Reference: http://www.cisco.com/c/en/us/td/docs/wireless/prime_infrastructure/1- 2/configuration/guide/pi_12_cg/maps.html Table 6-4 Question No : 8 100% Success with Our Dumps 4

5. Cisco 300-360 : Braindumps Questions A network engineer is performing a site survey in preparation for an installation. Which three hardware parameters must be inspected? (Choose three.) A. routing protocol used B. PoE capability C. switch STP capability D. distance of antenna to communications room E. switch port availability F. distance of access point to communications room Answer: B,E,F Question No : 9 A customer wants to upgrade their current wireless infrastructure to support wireless voice capabilities. When using a voice readiness assessment tool, the customer notes that multiple areas have failed to meet the requirements. How should the customer resolve this issue? A. Reduce the maximum threshold on the voice readiness tool to -67 dBm. B. Perform a site survey to position access points in the facility? C. Ensure that there is a 1 to 5 ratio of monitor mode to local mode access points D. Increase the power on all the access points to 25mW or more. Answer: A Explanation: https://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Mobility/WiFiLBS- DG/wifich5.html Question No : 10 A customer has determined that aesthetics is a primary concern for their upcoming guest deployment. Which design consideration can be leveraged to address this concern? A. Paint the access point to cover the LED from being noticeable B. Use enclosures to hide the wireless infrastructure in the surrounding environment C. Deploy environmentally friendly cabling components to blend into the environment. 100% Success with Our Dumps 5

6. Cisco 300-360 : Braindumps Questions D. Use AIR-AP-BRACKET-1 to allow for greater mounting locations Answer: C 100% Success with Our Dumps 6