1 / 8

Interference and Model Check Analysis for Type A and Type B Components

This document reviews the interference and dimensional checks between Type A and Type B components, focusing on specific areas where improvements are needed. Notably, the chamfer at the bottom of Type B has been identified (Se141-115) as a potential enhancement to improve transition. Furthermore, the edge distance of the hole (Se141-116) raises concerns, prompting a discussion on whether the hole can be repositioned to enhance design integrity. Recommendations include moving and adjusting these holes to a specified depth of 1.375 inches.

keaton-fowler
Download Presentation

Interference and Model Check Analysis for Type A and Type B Components

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. TF / MC Interference and MC Model Check 4/25/2005

  2. Type A Type B

  3. Type A

  4. Bottom of Type B Chamfer here would help

  5. se141-115 Poor transition here.

  6. Se141-116 Not much hole edge distance here. Can hole be moved down? See next page

  7. These holes could me moved (up and down respectively) and change to a specified depth of the tapped hole (depth of 1.375).

More Related