Easy Edge Banding For Plywood

1. Easy Edge Banding For Plywood Edge banding can be done in a variety of ways. You can buy thin veneers that can be applied to the plywood either with contact cement or by using the banding tape that comes with an iron on adhesive. While this is the most commonly used option, it is by no means durable and can actually limit your design options. Here is an easy technique demonstrated that will help you go ahead with plywood edge banding. Step 1: Cutting The Banding To cut the banding, you'll need to use a table saw. A band saw with a fence can also be utilized. The thickness of your banding will depend on your design, but it should be at least 1/8 of an inch thick. Set the fence of the saw to the desired dimension. While cutting thin parts in this fashion can increase the danger in using the saw, this will allow you to get uniform cuts every time, especially if you need a lot of banding. Depending on the design of the saw, you may need to remove the blade guard. Step 2: Applying The Banding To apply the edge banding, first clamp your piece in a table. Apply an even coat of glue along only the edge of the plywood. Because of the material is wider than the thickness of the plywood, this will keep excess glue from dripping onto the veneer. It will also keep the banding from slipping around when applied. Spread the glue evenly over the surface using a brush or your finger.

2. Step 3: Trimming The Banding After the glue has cured, remove the clamps and tape. Using a chisel, cut away any large pieces of dried glue, being careful not to cut into the veneer of the plywood. Conclusion With a little practice, this technique can allow you to quickly enhance many of your wood working projects.