1 / 53

Telecommunication Technologies

Telecommunication Technologies. Week 9 HDLC (ISO 33009, ISO 4335). HDLC (High level Data Link Control) ISO 33009, ISO 4335. Stations: Primary, Secondary, Combined Link Balance or Unbalanced Transfer Modes NRM, ABM, ARM Frames I-frames, S-frames, U-frames. HDLC Syntax.

Download Presentation

Telecommunication Technologies

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Telecommunication Technologies Week 9 HDLC (ISO 33009, ISO 4335)

  2. EIE325: Telecommunication Technologies

  3. EIE325: Telecommunication Technologies

  4. HDLC (High level Data Link Control) ISO 33009, ISO 4335 Stations: Primary, Secondary, Combined Link Balance or Unbalanced Transfer Modes NRM, ABM, ARM Frames I-frames, S-frames, U-frames HDLC Syntax EIE325: Telecommunication Technologies

  5. HDLC Station Types • Primary station • Controls operation of link • Frames issued are called commands • Maintains separate logical link to each secondary station • Secondary station • Under control of primary station • Frames issued called responses • Combined station • May issue commands and responses EIE325: Telecommunication Technologies

  6. HDLC Link Configurations • Unbalanced • One primary and one or more secondary stations • Supports full duplex and half duplex • Balanced • Two combined stations • Supports full duplex and half duplex EIE325: Telecommunication Technologies

  7. HDLC Transfer Modes • Normal Response Mode (NRM) • Unbalanced configuration • Primary initiates transfer to secondary • Secondary may only transmit data in response to command from primary • Used on multi-drop lines • Host computer as primary • Terminals as secondary EIE325: Telecommunication Technologies

  8. HDLC Transfer Modes • Asynchronous Balanced Mode (ABM) • Balanced configuration • Either station may initiate transmission without receiving permission • Most widely used • No polling overhead EIE325: Telecommunication Technologies

  9. HDLC Transfer Modes • Asynchronous Response Mode (ARM) • Unbalanced configuration • Secondary may initiate transmission without permission form primary • Primary responsible for line • Rarely used EIE325: Telecommunication Technologies

  10. HDLC Frame Types • Three types of frames • I-frames : Information (data) • S-frames : Supervisory (ARQ) • U-frames : Unnumbered (other) • Frame structure the same in each case EIE325: Telecommunication Technologies

  11. Frame Structure • Synchronous transmission • All transmissions in frames • Single frame format for all data and control exchanges EIE325: Telecommunication Technologies

  12. Frame Structure Diagram EIE325: Telecommunication Technologies

  13. Flag Fields • Delimit frame at both ends • 01111110 • May close one frame and open another • Receiver hunts for flag sequence to synchronise • Bit stuffing used to avoid confusion with data containing 01111110 • 0 inserted after every sequence of five 1s • If receiver detects five 1s it checks next bit • If 0, it is deleted • If 1 and seventh bit is 0, accept as flag • If sixth and seventh bits 1, sender is indicating abort EIE325: Telecommunication Technologies

  14. Bit Stuffing • Example with possible errors

  15. Address Field • Identifies secondary station that sent or will receive frame • Usually 8 bits long • May be extended to multiples of 7 bits • LSB of each octet indicates that it is the last octet (1) or not (0) • All ones (11111111) is broadcast EIE325: Telecommunication Technologies

  16. Control Field • Different for different frame type • Information - data to be transmitted to user (next layer up) • Flow and error control piggybacked on information frames • Supervisory - ARQ when piggyback not used • Unnumbered - supplementary link control • First one or two bits of control field identify frame type EIE325: Telecommunication Technologies

  17. Control Field Diagram EIE325: Telecommunication Technologies

  18. Poll/Final Bit • Use depends on context • Command frame • P bit • 1 to solicit (poll) response from peer • Response frame • F bit • 1 indicates response to soliciting command EIE325: Telecommunication Technologies

  19. Information Field • Only in information and some unnumbered frames • Must contain integral number of octets • Variable length EIE325: Telecommunication Technologies

  20. Frame Check Sequence Field • FCS • Error detection • 16 bit CRC • Optional 32 bit CRC EIE325: Telecommunication Technologies

  21. HDLC Operation • Exchange of information, supervisory and unnumbered frames • Three phases • Initialisation • Data transfer • Disconnect EIE325: Telecommunication Technologies

  22. EIE325: Telecommunication Technologies

  23. HDLC commands EIE325: Telecommunication Technologies

  24. E.g.: Setup and disconnect • SABME: Set ABM, 7-bit sequence numbers • UA: Unnumbered ACK • DISC: Disconnect EIE325: Telecommunication Technologies

  25. E.g.: Exchange • I,n,m: Information • n & m are sender and receiver sequence numbers • RR: Receive ready EIE325: Telecommunication Technologies

  26. E.g.: Busy • RNR: Receive not ready EIE325: Telecommunication Technologies

  27. E.g.: Reject recovery • REJ: Reject EIE325: Telecommunication Technologies

  28. E.g.: Timeout recovery EIE325: Telecommunication Technologies

  29. Telecommunication Technologies Week 9 Synchronisation

  30. Asynchronous and Synchronous Transmission • Timing problems require a mechanism to synchronise the transmitter and receiver • data rate • bit duration • inter-frame spacing • Two solutions • Asynchronous (data not contiguous) • Synchronous (data blocks contiguous) EIE325: Telecommunication Technologies

  31. Presumptions • Serial, not Parallel Transmission • One bit per signal element • Sender and receiver’s clocks are different • Errors in timing (sampling) as well as amplitude (quantisation) EIE325: Telecommunication Technologies

  32. Asynchronous • Data transmitted one character (5-8 bits) at a time • Timing only needs maintaining within each character • Resynchronise for each character • Idle (binary 1) between characters • Start bit is a binary 0 EIE325: Telecommunication Technologies

  33. Asynchronous (diagram) EIE325: Telecommunication Technologies

  34. Asynchronous Timing Error • 10kbps transmission … bit duration of 0.1ms. • Over 8 bits a 5% timing error is acceptable • A 6% timing error is not. EIE325: Telecommunication Technologies

  35. In a steady stream, interval between characters is uniform (length of stop element) In idle state, receiver looks for transition 1 to 0 Then samples next seven intervals (char length) Then looks for next 1 to 0 for next char Simple Cheap Overhead of 2 or 3 bits per char (~20%) Good for data with large gaps (keyboard/terminal) Asynchronous - Behavior EIE325: Telecommunication Technologies

  36. Asynchronous Errors • Timing errors • extreme discrepancy between sender and receiver’s clocks. • Framing errors • Erroneous start bits EIE325: Telecommunication Technologies

  37. Synchronous - Bit Level • Block of data transmitted without start or stop bits • Clocks must be synchronised • Can use separate clock line • Good over short distances • Subject to impairments • Embed clock signal in data • Manchester encoding • Carrier frequency (analog) EIE325: Telecommunication Technologies

  38. Synchronous - Block Level • Need to indicate start and end of block • Use preamble and “postamble” • e.g. series of SYN (hex 16) characters • e.g. block of 11111111 patterns ending in 11111110 • More efficient (lower overhead) than asynchronous • E.g. HDLC EIE325: Telecommunication Technologies

  39. Synchronous e.g. HDLC EIE325: Telecommunication Technologies

  40. Echo Cancellation • Transceiver: Transmitter/Receiver • Two parties transmit on the same data path simultaneously • Each is aware of their own transmission and can subtract that from the resultant to receive the other! EIE325: Telecommunication Technologies

  41. Telecommunication Technologies Week 9 Interfacing

  42. Interfacing • Data processing devices (or data terminal equipment, DTE) do not (usually) include data transmission facilities • Need an interface called data circuit terminating equipment (DCE) • e.g. modem, NIC • DCE transmits bits on medium • DCE communicates data and control info with DTE • Done over interchange circuits • Clear interface standards required EIE325: Telecommunication Technologies

  43. Interfacing EIE325: Telecommunication Technologies

  44. Characteristics of Interface • Mechanical • Connection plugs • Electrical • Voltage, timing, encoding • Functional • Data, control, timing, grounding • Procedural • Sequence of events EIE325: Telecommunication Technologies

  45. Two examples • Modem • ISDN EIE325: Telecommunication Technologies

  46. E.g.: V.24/EIA-232-F • ITU-T V.24 specifies functional and procedural • EIA-232-F (USA) (originally RS-232): • Mechanical ISO 2110 • Electrical V.28 • Functional V.24 • Procedural V.24 EIE325: Telecommunication Technologies

  47. Mechanical Specification

  48. Data Pins EIE325: Telecommunication Technologies

  49. Control Pins EIE325: Telecommunication Technologies

More Related