1 / 36

Power Management in IEEE 802.11

Power Management in IEEE 802.11. Yu-Chee Tseng @CS.NCTU Possible Access Sequences for a STA in PS Mode PS in Infrastructure Network PS in Ad Hoc Network. Motivation. Since mobile hosts are supported by battery power, saving battery as much as possible is very important.

jeffreyhunt
Download Presentation

Power Management in IEEE 802.11

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Power Management in IEEE 802.11 Yu-Chee Tseng @CS.NCTU Possible Access Sequencesfor a STA in PS Mode PS in Infrastructure Network PS in Ad Hoc Network

  2. Motivation • Since mobile hosts are supported by battery power, saving battery as much as possible is very important. • Power management in 802.11 • in infrastructure network vs. ad hoc network • PCF vs. DCF

  3. Introduction • Power management modes • Active mode (AM) • Power Save mode (PS) • Power consumption of ORiNOCO WLAN Card

  4. Basic Idea • AP or source hosts buffer packets for hosts in PS mode. • AP or sources send TIM periodically. • TIM = traffic indication map (a partial virtual bitmap associated with station id) • TIM is associated with beacon. • Hosts in PS mode only turn on antenna when necessary. • Hosts in PS mode only “wake up” to monitor TIM.

  5. Basic Idea: TIM Types • TIM : • transmitted with every beacon (for Unicast) • Delivery TIM (DTIM): • transmitted less frequently (every DTIM_interval) • for sending buffered broadcast packets • Ad hoc TIM (ATIM): • transmitted in ATIM-Window by stations who want to send buffered packets • structured the same as TIM

  6. Basic Idea:An Illustration Example

  7. Possible Access Sequencesfor a STA in PS Mode immediate response immediate response with fragmentation deferred response

  8. Power Saving Sequences • 802.11 stations shut down the radio transceiver and sleeping periodically to increase battery life. • During sleeping periods, access points buffer any unicast frames for sleeping stations. • These frames are announced by subsequent Beacon frames. • To retrieve buffered frames, newly awakened stations use PS-Poll frames.

  9. Immediate Response • AP can respond immediately to the PS-Poll • PS-Poll frame contains an Association ID in the Duration/ID field so AP can determine which frames were buffered for the MS. • Since Duration is not used, it assumes • NAV = SIFS + ACK • Although the NAV is too short, the medium is seized by data frame.

  10. Example: Immediate Response

  11. Immediate Response with Fragmentation • If the buffered frame is large, it may require fragmentation. ** note: the change of NAVs

  12. Deferred Response • After being polled, the AP may decide to respond with a simple ACK. • although promised, AP does not act immediately • AP may do regular DCF activities • the PS station must remain awake until it is delivered

  13. fig. 3-21 • The PS station must stay awake until the next Beacon frame in which its bit in TIM is clear. • Fragmentation is possible too.

  14. PS in Infrastructure Network

  15. Power Management in Infrastructure Networks • All traffic for MSs must go through APs, so they are an ideal location to buffer traffic. • APs are aware of MSs’ power management state. • APs have two power management-related tasks. • Determine whether a frame should be delivered • Announce periodically which stations have frames waiting for them.

  16. Assumptions and Models • Assumptions: • TIM interval (beacon interval) and DTIM interval are known by all hosts • requires time synchronization • Stations in PS mode are known or can be predicted. • Two Operational Models: • under DCF (contention-based) • under PCF (contention-free): omitted

  17. Under DCF (Infrastructure Mode) • Basic assumption: • use CSMA/CA to access the channel • RTS, CTS, ACK, PS-Poll are used to overcome the hidden-terminal problem

  18. Operations of TIM (in DCF) • AP periodically broadcasts beacon with TIM. • Hosts in PS must wake up to check TIM. • Check for their IDs. • If found having packets buffered in AP, send PS-Poll to AP (by contention?). • Otherwise, go back to PS mode. • AP replies PS-poll with ACK. • The receiver must remain in active mode until it receives the packet. • AP uses CSMA/CA to transmit to stations.

  19. Buffered Frame Retrieval Process for Two Stations • Station 1 has a listen interval of 2 while Station 2 has a listen interval of 3.

  20. Delivering Multicast and Broadcast Frames: the Delivery TIM (DTIM) • Frames are buffered whenever any station associated with the AP is sleeping. • Buffered broadcast and multicast frames are saved using AID = 0. • AP sets the first bit in the TIM to 0. • At a fixed number of Beacon intervals, a DTIM is sent. • Buffered broadcast and multicast traffic is transmitted after a DTIM Beacon.

  21. Buffer Transmission after DTIM • DTIM interval = 3

  22. (omitted)Under PCF (Infrastructure Mode) • Basic Assumption: • Point coordinator uses CF-Polling to access the channel. • AP only maintains the CF-Pollable stations.

  23. Operations of TIM (PCF) • AP broadcasts beacon with TIM. • Hosts in PS mode checks TIM for their IDs. • If there are buffered packets in AP, the host must remain in Active Mode until being polled. • O/w, the station goes back to PS mode. • Then AP polls those PS stations. • When being polled, the station (in PS mode) sends PS-Poll to AP. • Then AP sends buffered packets to the station. • (See next page.) • AP must poll stations in PS mode first.

  24. Beacon_ Interval TIM TIM Poll Poll Data TIM Data AP STA 1 in PS mode PS-poll ACK STA 2 in PS mode PS-poll ACK

  25. Operations of DTIM (PCF) • All CF-pollable stations need be in Active Mode when AP broadcasts DTIM. • Immediately after DTIM, AP sends out the buffered broadcast/multicast packets.

  26. Beacon_ Interval Broadcast Data TIM TIM DTIM AP STA 1 in PS mode STA 2 in PS mode

  27. PS in Ad Hoc Mode(without base station)

  28. Announcement TIM (ATIM) • The ATIM frame is a message to keep the transceiver on because there is a pending data frame. • All stations in an IBSS listen for ATIM frames during specified periods after Beacon transmissions. • Stations that do not receive ATIM frames are free to conserve power.

  29. ATIM Usage

  30. PS in Ad Hoc Mode • Assumptions: • beacon interval & ATIM window are known by all hosts • Each station predicts which stations are in PS mode. • The network is fully connected. • Basic Method: • CSMA/CA is used to access the channel. • RTS, CTS, ACK, PS-Poll are used to overcome hidden terminal.

  31. ATIM Window • If the beacon is delayed due to a traffic overrun, the useable portion of the ATIM window shrinks.

  32. Operations of ATIM • All stations should be in active mode during ATIM window. • The station which completes its backoff procedure broadcasts a beacon. • Sending beacon is based on contention. • Any beacon starts the ATIM window. • Once a beacon is heard, the rest beacons are inhibited.

  33. In ATIM window, each source station having buffered packets to be sent contends to send out its ATIM. • If a host finds it is in the ATIM name list, • send an ACK to the sender. • remain in the ACTIVE mode throughout the beacon interval. • If the host is not in the name list, • it can go back to the PS mode. • After ATIM window, • all stations use CSMA/CA to send the buffered packets • basic idea: data packet >> ATIM control frames • only those hosts who have ACKed the ATIM have such opportunity.

  34. ATIM Example

  35. ATIM Example (STA 1 Waking Up STAs 2, 3, and 4)

  36. Summary of PS • infrastructure network • PCF • DCF (omitted) • ad hoc network • DCF

More Related