1 / 8

Welcome to the ECEN 325 LAB!

Welcome to the ECEN 325 LAB!. TA: Younghoon Song (john) Office Hours: T & R 10-11am Office : WBRC 114. Important!. To run PSPICE simulations in the ECE Department computers you have to temporarily save your files (Eg. schematics) in the computer desktop.

jack
Download Presentation

Welcome to the ECEN 325 LAB!

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Welcome to the ECEN 325 LAB! TA: Younghoon Song (john) Office Hours: T & R 10-11am Office : WBRC 114

  2. Important! • To run PSPICE simulations in the ECE Department computers you have to temporarily save your files (Eg. schematics) in the computer desktop.

  3. ECEN 325 Lab 1: Network Analysis and Bode plots By: Joselyn Torres

  4. Part A Build the following circuit: CH2+ (Red) CH1+(Red) CH2-(Black) CH1-(Black) R = 1026  1K C = 47nF f-3dB  3.3KHz

  5. High Z Option: • First, press “Shift” then “Enter” ( You should see “A: MOD MENU”) • Then, press “>” three times until you find “D: SYS MENU” • Next, press “v” twice until you find “50 Ohm” • Then, press “>” once until you see “High Z” • Finally, press “Enter”

  6. Measurements Approach 1: Measure t with the cursors  Phase = 360 * t * Frequency (Function generator) Approach 2: Measure the  Phase

  7. Part B (Instructions) • Go to : Program => HP BenchLink Suite => HP BenchLink Arb • Go to: =>Options => Configure Interface =>Interface: National Instruments AT-GPIB or GPIB-PC2 => Instruments: HP33120A Waveform Generator Address 10 => press Ok • Then just follow the instructions in the manual

  8. Part C Build the following circuit: CH2+ (Red) CH1+ (Red) R1 = 967.5  1K R2 = 96.75K  100K C = 47nF CH2- (Black) CH1- (Black) Instructions: • Apply a 6Vpp sinusoid from the function generator to the input • Find the -3dB signal attenuation frequency f-3dB(this the point where the output amplitude is • 0.707 times the input amplitude, e.g. if the input is 6Vpp the output voltage should be 4.24V) • 3. Find the -40dB signal attenuation frequency f-40dB(this the point where the output amplitude is • 0.01 times the input amplitude, e.g. if the input is 6Vpp the output voltage should be 60mV)

More Related