PRESENTED BY ARUNBOSE db college

1 / 19

# PRESENTED BY ARUNBOSE db college - PowerPoint PPT Presentation

MEMRISTOR. PRESENTED BY ARUNBOSE db college. Memristor – The Fourth Fundamental Circuit Element . Introduction. Currently known fundamental passive elements – Resistors, Capacitors & Inductors. Does a 4 th passive element exist..?

I am the owner, or an agent authorized to act on behalf of the owner, of the copyrighted work described.

## PowerPoint Slideshow about 'PRESENTED BY ARUNBOSE db college' - holden

Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author.While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server.

- - - - - - - - - - - - - - - - - - - - - - - - - - E N D - - - - - - - - - - - - - - - - - - - - - - - - - -
Presentation Transcript
MEMRISTOR

### PRESENTED BY ARUNBOSE db college

Introduction
• Currently known fundamental passive elements – Resistors, Capacitors & Inductors.
• Does a 4th passive element exist..?
• Leon O. Chua formulated Memristor theory in his paper “Memristor-The Missing Circuit Element” in 1971.
• Memistors are passive two terminal circuit elements.
• Behaves like a nonlinear resistor with memory.
History Of Memristor
• Four fundamental circuit variables- current i, voltage v, charge q, and flux linkage φ
• Six possible combinations of these four variables

Resistor(dv=Rdi), Capacitor(dq=Cdv), Inductor(dφ=Ldi), q(t)=∫i(T)dT, φ(t)=∫v(T)dT

• The 6th relation defines memristance as dφ=Mdq
So what is Memristance?
• Memristance is a property of an electronic component.
• When charge flows in one direction, its resistance increases, and if direction is reversed, resistance decreases.
• When v=0, charge flow stops & component will ‘remember’ the last resistance it had.
• When the flow of charge regains, the resistance of the circuit will be the value when it was last active.
Memristor Theory
• Two terminal device in which magnetic flux Φm between its terminals is a function of amount of electric charge q passed through the device.
• M(q) = dΦm/dq
• M(q) = [dΦm/dt] / [dq/dt] = V/I
• V(t) = M(q(t))I(t)
• The memristor is static if no current is applied.
• If I(t)=0, then V(t)=0 and M(t) is a constant. This is the essence of the memory effect.
Physical analogy for a memristor
• Resistor is analogous to a pipe that carries water.
• Water(charge q), input pressure(voltage v), rate of flow of water(current i).
• In case of resistor, flow of water is faster if pipe is shorter and/or has a larger diameter.
• Memristor is analogous to a special kind of pipe that expands or shrinks when water flows through it
• The pipe is directive in nature.
• If water pressure is turned off, pipe will retain its most recent diameter, until water is turned back on.
Titanium dioxide memristor
• On April 30, 2008, a team at HP Labs led by the scientist R. Stanley Williams announced the discovery of a switching memristor.
• It achieves a resistance dependent on the history of current using a chemical mechanism.
• The HP device is composed of a thin (5nm) Titanium dioxide film between two Pt electrodes.
• Initially there are two layers, one slightly depleted of Oxygen atoms, other non-depleted layer.
• The depleted layer has much lower resistance than the non-depleted layer.
Microscopic image of memristor row
• An atomic force microscope image of a simple circuit with 17 memristors lined up in a row.  Each memristor has a bottom wire that contacts one side of the device and a top wire that contacts the opposite side.  The devices act as 'memory resistors', with the resistance of each device depending on the amount of charge that has moved through each one. The wires in this image are 50 nm wide, or about 150 atoms in total width.
v-i chara..(cont.)
• The most common v-i trace is a ‘figure 8’ or a ‘pinched loop’
• For this current i=0, when voltage v=0.
• On the application of electric field, oxygen vacancies drift, changing boundary between high & low resistance layers.
• Memristance is only displayed when the doped layer & depleted layer both contribute to resistance.
• The device enters hysteresis when enough charge has passed through memristor & ions can no longer move.
Contribution of HP Labs
• HP Lab scientists were first to observe the ‘memristive behaviour’ in materials.
• Introduced the titanium dioxide memristor.
• Introduced memristance formula for devices.
Memristance formula
• For linear ionic drift in a uniform field with average ion mobilityµv,
• The 2nd term in the parentheses which contribute more to memristance becomes larger when D is in the nanometer range.
• Thus memristance is important characteristics of a device when critical dimension shrink to nanometer scale.
Operation as a switch
• For some memristors, applied current or voltage will cause a great change in resistance.
• The semiconductor film has a region of high conc. of dopants having low resistance RON & remaining portion having zero dopant conc. and much higher resistance ROFF.
• By application of external bias, we can move the boundary to adjust the device resistance from RON to ROFF.
• can now think about fabricating a non-volatile random access memory (RAM) – or memory chips that don't forget the data when a computer is shut off.Memristors carries a memory of its past.
• Replace today’s commonly used dynamic random access memory (DRAM).
• Denser cells allow memristor circuits to store more data than flash memory.
• The Hewlett-Packard team has successfully created working circuits based on memristors that are as small as 15 nanometers. Ultimately, it will be possible to make memristors as small as about four nanometers.