how to make a wooden toolbox
Download
Skip this Video
Download Presentation
DIY to make wooden toolbox

Loading in 2 Seconds...

play fullscreen
1 / 11

DIY to make wooden toolbox - PowerPoint PPT Presentation


  • 144 Views
  • Uploaded on

Make your own wooden toolbox by following these simple steps.

loader
I am the owner, or an agent authorized to act on behalf of the owner, of the copyrighted work described.
capcha
Download Presentation

PowerPoint Slideshow about 'DIY to make wooden toolbox' - haysnyc


An Image/Link below is provided (as is) to download presentation

Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author.While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server.


- - - - - - - - - - - - - - - - - - - - - - - - - - E N D - - - - - - - - - - - - - - - - - - - - - - - - - -
Presentation Transcript
how to make a wooden toolbox

HowtoMake a WoodenToolbox

Informationsharedby: www.hays-nyc.com

things you will require
THINGS YOU WILL REQUIRE
  • 6’ 1×10 clear pine
  • 6’ 1×6 clear pine
  • 2-4’ 1 ¼“daimeter dowel
  • Wood glue
  • Wood screws
  • Pilot drill
  • Bit brace
  • Pull saw
  • Sandpaper
now let s start

Now Let’s Start

Making Wooden Toolbox

step 1
Step 1:
  • Firstly, begin by deciding on a particular size for the wooden toolbox. As a suggestion, try making it a little bigger so that it can accommodate longer tools easily.
  • Now ensure that wood for the box has square ends. Use T-square to mark lines about an inch from the end and trim them down with a saw.
step 2
Step 2:
  • Once done with trimming the wooden squares, measure and begin cutting them.
  • Because, the bottom and side of the toolbox will have caps in the ends, you need to cut them a bit longer than other pieces.
step 3
Step 3:
  • Precisely design the end pieces and cut them. Measure six 1/4′’ to the bottom of 1×10 section and spot it on two banks of the board.
  • Connect the mark at 6 ¼’ with the arc and repeat the same for the other side.
step 4
Step 4:
  • Place the compass on 11” mark and draw a circle at 1 ¼’ mark hole. Cut out this section using a pull saw.
  • Drill a hole in the handle using brace and bit. Make sure that that you place the center screw in the midpoint of 11” mark.
step 5
Step 5:
  • Use a rasp and clean the top of side piece. Remember to repeat the whole thing for the other section and you can use the first one as a stencil.
  • Attach the end pieces to the end of the board and screw them tight. 
step 6
Step 6:
  • Place the edge of side section over the end of bottom plank and screw it accurately. Make sure that you drive screws deep into the surface.
  • Use wooden glue to the section and hammer to make the joints stays resilient.
step 7
Step 7:
  • By now you will have a good frame for the toolbox. Simply add the longer sections between the two the triangular faces.
  • Use sand paper and provide proper finish at the ends, especially the handle of the toolbox.
ad