1 / 17

Adapting CMOS Active Pixel Sensors for HgCdTe Photodiodes

Adapting CMOS Active Pixel Sensors for HgCdTe Photodiodes. Zeynep Dilli, Neil Goldsman, Martin Peckerar, Nibir Dhar. Active Pixel Sensors. (adapted from El Gamal et al. and Yadid-Pecht et. al.). Source-Follower Active Pixel Sensor (SFAPS) Circuit.

given
Download Presentation

Adapting CMOS Active Pixel Sensors for HgCdTe Photodiodes

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Adapting CMOS Active Pixel Sensors for HgCdTe Photodiodes Zeynep Dilli, Neil Goldsman, Martin Peckerar, Nibir Dhar

  2. Active Pixel Sensors (adapted from El Gamal et al. and Yadid-Pecht et. al.)

  3. Source-Follower Active Pixel Sensor (SFAPS) Circuit • Simple version: 3 transistors (pixel reset, source follower, access), one photodiode • Not shown: Row read circuitry, a timed buffer connected to v_out and activated a set time after pixel access

  4. SFAPS Circuit • Operation: • Reset transistor gate pulsed, photodiode junction cap. charged up, source follower output follows • Photocurrent starts discharging, SF output follows • Access transistor gate pulsed, output cap.charged up • Bias current discharges output voltage linearly until the set read time for v_out

  5. SFAPS Circuit • Operation: • Reset transistor gate pulsed, photodiode junction cap. charged up, source follower output follows • Photocurrent starts discharging, SF output follows • Access transistor gate pulsed, output cap.charged up • Bias current discharges output voltage linearly until the set read time for v_out

  6. Operation: • Reset gate pulsed, photodiode charged up, SF output follows • i_pf discharges diode cap., SF output follows • Access gate pulsed, output cap. charged up • i_bias discharges output until the set read time for v_out

  7. APS Circuit + Output Transmission Gate • Modeling: • Photodiode modeled with capacitor in parallel with n p current sources • Dark current is modeled as a fixed DC current

  8. HgCdTe Photodiodes • Diode responsivity: ~4-5.5 for 10 μ radiation [1] • For a 40 μ by 40 μ diode, photocurrent~10s of μA, for light intensity ~1e-9 W/μ2 (sunlight in visible; source intensity for 10 μ radiation likely to be lower.) • Dark current ~4 nA for 100K and ~500 nA for 150 K (ARL data) • Diode needs to be reverse biased; however, higher reverse bias increases dark current significantly as well [1] Fukuda, Matsuura & Mori, 1984

  9. SFAPS circuit with HgCdTe diode; Idark=~4nA (T=100K)

  10. SFAPS circuit with HgCdTe diode; Idark=500nA(T=150K)

  11. SFAPS circuit operation with HgCdTe diode; Effect of Idark • If next stage is A/D converter, resolution depends on output voltage separation • Low Id: 1.26V-912mV=348 mV • High Id: 1.08V-812V=268mV • Highest detectable illumination range is also reduced.

  12. Approaches for Dark Current Compensation • Reduce the dark current of the diode itself: • Cool the diodes (not applicable in this project) • Reduce the bias across the diode with the design of the input and readout circuits • Transimpedance amplifiers [1] • Direct injection [2,3] • Pseudoactive pixel sensors [4] • Cancel the dark current of each diode during operation: • Frame differencing schemes [5] • Extra unilluminated pixels and current subtraction [4,6] [1] D’Souza, Wijewarnasuriya, Poksheva [2] Scribner, Kruer, Killiany, 1990 [3] Bailey, Kozlowski, Chen et al, 1991 [4] Shih, Wu, 2004 [5] Ma, Chen, 1999 [6] Abdallah, Dubaric, Nilsson et al., 2001

  13. SFAPS Circuit • Advantages: • Small circuit, just three transistors per pixel: Large fill factor possible • Photodiode operation isolated from readout circuit • Flexibility in design with respect to timing design vs. power consumption vs. readout speed vs. resolution • DISADVANTAGE: Diode is reverse biased quite highly (at around 3.5V for out previous example)---not usable for HgCdTe diodes in basic form

  14. Transimpedance Amplifier • Converts diode current input into voltage level at output of common-source amplifier PMOS • Sets diode bias by the source bias of the gate-drain shortedbiasing PMOS diode_n diode_p

  15. Transimpedance Amplifier---Selecting Bias Point Diode bias set around -300 mV---better than SFAPS, still not low enough for HgCdTe. Working on improving this circuit.

  16. Transimpedance Amplifier---Operation

  17. Future Work • Investigate • Transconductance amplifiers (further) • Direct injection circuits • Different biasing schemes • Unilluminated extra pixels and dark current cancellation • Consider • HgCdTe requirement: Very low reverse bias • Hybrid integration [1] allows more space for readout circuitry per pixel; still, optimize circuits for power consumption • Timing requirements and tradeoffs? (Extrapolate from SFAPS work) • Sensitivity requirements and tradeoffs? (Extrapolate from SFAPS work) [1] Bailey, Kozlowski, Chen et.al., 1991 and later work

More Related