1 / 9

FET Current Mirrors

FET Current Mirrors. ECE 2204. Current Sources . Ideal independent current sources are difficult to make and are almost impossible to fabricate on an integrated circuit. Instead, current mirrors are fabricated.

eudora
Download Presentation

FET Current Mirrors

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. FET Current Mirrors ECE 2204

  2. Current Sources • Ideal independent current sources are difficult to make and are almost impossible to fabricate on an integrated circuit. • Instead, current mirrors are fabricated. • These are circuits that contain two or more FETs, where the drain of one of the FETs is connected to the rest of the circuit. • This FET is operating in the saturation/pinch-off mode. Thus, it can be thought of as a dependent current source. • The value of this dependent current source is determined by the operating conditions of the other FETs in the current mirror, not by the operating condition of the rest of the circuit (at least over a certain range of currents).

  3. 2 Transistor Current Mirror

  4. Common Design in Current Mirrors • At least two transistors • Two transistors are wired in parallel • shared VGS • One transistor has the drain and gate tied together • VDS > VGS – VTN; it is in saturation

  5. Drain Current in M1

  6. Bias Condition of M2 • M2 is assumed to also be in saturation. • This depends in part on the rest of the circuit above M2 • If the circuit above M2 requires too much current, then M2 will be forced into the triode/nonsaturation region. At which point, the current mirror circuit is not functioning properly – which means someone didn’t design their part of the circuit to the correct specification.

  7. Drain Current of M2

  8. Current Mirror with Enhancement Load

  9. Modified Wilson Current Mirror

More Related