1 / 13

Mold Layout and Modification Suggestions for Part

This document provides information on the mold layout, gating points, draft angles, sliders, lifters, ejector pin marks, and wall thickness analysis for a specific part. It also includes modification suggestions for thin materials and difficult-to-machine surfaces. Additionally, surface finish and mold layout specifications are addressed.

ericka
Download Presentation

Mold Layout and Modification Suggestions for Part

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. General Information 105.6mm 17.0mm 79.2mm

  2. Parting Line Cavity PL Core Please confirm the parting line, see green line.

  3. Gate Location Gate Location Sub gate here, please confirm if you can accept gating point here.

  4. Draft angle information Draft Angle No draft angle on green surface, we need to put 1 degree for releasing the part from the mold.

  5. Sliders No sliders needed for this part. Plastopia Molding Limited

  6. Lifters No lifters needed for this part. Plastopia Molding Limited

  7. Ejector Pins Marks Ejector pins marks will be left on the part, please confirm.

  8. Wall thickness Analysis-1 Too thick on pointed areas, which will cause sink marks. Suggest to core out some material

  9. Wall thickness Analysis-2 Too thick on pointed areas, which will cause sink marks. Suggest to core out some material Plastopia Molding Limited

  10. Modification Suggestion-1 What’s function for the thin material? For ultrasonic welding? If not, we suggest to remove them and make flat surface for better molding Plastopia Molding Limited

  11. Modification Suggestion-2 Difficult to machine these radius-red surfaces. Can we remove all radius on the top of ribs? Plastopia Molding Limited

  12. Surface Finish Please specify the texture or engraving.

  13. Mold Layout

More Related