1 / 27

Frictional Cooling

Frictional Cooling. Columbia University & the Max-Planck-Institute. R. Galea, A. Caldwell, S.Schlenstedt, H. Abramowicz. What is Frictional Cooling (FC)? Simulation of the frontend of a Muon Collider based on FC Targetry & Capture Magnet Drift Region Phase Rotation Cooling section

donny
Download Presentation

Frictional Cooling

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Frictional Cooling Columbia University & the Max-Planck-Institute R. Galea, A. Caldwell, S.Schlenstedt, H. Abramowicz • What is Frictional Cooling (FC)? • Simulation of the frontend of a Muon Collider based on FC • Targetry & Capture Magnet • Drift Region • Phase Rotation • Cooling section • Reacceleration • Physics covered by simulations • Energy loss mechanisms, Nuclear & electronic • Muonium Formation • m- capture • Experimental results & plans • Future studies 2004 Workshop on Muon Collider Simulation

  2. What is Frictional Cooling? Nuclear scattering, atomic excitation, charge exchange… muon too slow to ionize 1/2 from ionization At high energy end change is only logarithmic whereas it is roughly proportional to speed at low energies Bring muons into a kinetic energy range where the dT/ds increases with kinetic energy (T)

  3. A constant accelerating force (an Electric field (E)) can be applied to the muons resulting in an equilibrium kinetic energy Same as freefall and reaching terminal velocity Gravity opposing friction

  4. A strong solenoidal field (B) is needed to guide the muons until they are cooled, so apply EB to get below the dT/ds peak

  5. Oscillations around equilibrium limits final emittance

  6. Yield is a critical issue: • In this regime dT/ds extremely large • Slow ms don’t go far before decaying d = 10 cm sqrt(T) T in eV • m+ forms Muonium • m- is captued by Atom • Low average density (gas) • Make Gas cell long as you want but transverse dimension (extraction) small. s(Mm) dominates over e-strippingin all gases except He s small above electron binding energy, but not known. Keep T as high as possible

  7. Simulation of Muon Collider based on FC:

  8. Detailed Simulation Full MARS target simulation, optimized for low energy muon yield: 2 GeV protons on Cu with proton beam transverse to solenoids (capture low energy pion cloud).

  9. Target System • cool m+ & m- at the same time • calculated new symmetric magnet with gap for target GeV

  10. Target & Drift Optimize yield • Optimize drift length for m yield • Some p’s lost in Magnet aperture • Only Muons at the end of 28m were tracked through the rest of the system

  11. 0.4m 28m p’s in red m’s in green GEANT3.21 simulation View into beam

  12. Phase Rotation: • Attempt simple form • Vary t1,t2 & Emax for maximum low energy yield Emax=5MV/m t1=100ns t2=439ns

  13. Simulation of the cooling cell: • Length=11m, Radius=0.2m • He density 1.25x10-4g/cm3 • Assume uniform Bz=5T • Muons hitting the cell walls before reaching equil. T are considered lost • Field extends outside cooling cell but is damped exponentially • Smoothly alternate field in order to compensate ExB drift

  14. Simulation of the cooling cell: • Initial longitudinal reacceleration to get beamlets out of cooling section E

  15. Scattering Cross Sections • Scan impact parameter and calculate q(b), ds/dq from which one can get lmean free path • Use screened Coulomb Potential (Everhart et. al. Phys. Rev. 99 (1955) 1287) • Simulate all scatters q>0.05 rad • Simulation accurately reproduces ICRU tables

  16. Difference in m+ & m- energy loss rates at dE/dx peak • Partly Due to charge exchange for m+ • parameterized data from Agnello et. al. (Phys. Rev. Lett. 74 (1995) 371) • Only used for the electronic part of dE/dx

  17. Muonium Formation Simulate the effect of muonium formation in the tracking, an effective charge as given by sI/(sF+sI) was used

  18. For m- the capture cross sections were parameterized and included in the simulation Although earlier studies showed promising results for m- this scheme has not been fully investigated for this flavor. using calculations of Cohen (Phys. Rev. A. Vol 62 022512-1)

  19. Out of the Cooling Cell: At z=11m

  20. Beam Characterization

  21. Muon Acceleration: • Standalone study take the beam as described and accelerate to a final beam momentum of 147 MeV/c at 30% survival probability RMS 1ms to 3ns RMS 1.2MeV/c to 5MeV/c

  22. Results: • Simulation of previous scheme yielded final beam emittances of • 2-6x10-11 (pm)3 • At yields of 0.001-0.003 m+/GeV proton. • Yield could be better yet emittance is better than ”required” • Cooler beams • smaller beam elements • less background • lower potential radiation hazard from neutrinos 1.7x10-10 (pm)3

  23. Nevis Experiment already reported at NuFact03 R.Galea, A.Caldwell, L.Newburgh, Nucl.Instrum.Meth.A524, 27-38 (2004) arXiv: physics/0311059 RAdiological Research Accelerator Facility • Perform TOF measurements with protons • 2 detectors START/STOP • Thin entrance/exit windows for a gas cell • Some density of He gas • Electric field to establish equilibrium energy • NO B field so low acceptance • Look for a bunching in time • Can we cool protons?

  24. Results of RARAF experiment • Various energies/gas pressures/electric field strengths indicated no cooled protons • Lines are fits to MC & main peaks correspond to protons above the ionization peak Experiment showed that MC could reproduce data under various conditions. Simulations of Frictional Cooling is promising. Exp. Confirmation still desired. Low acceptance but thicker windows was the culprit

  25. Frictional Cooling Demonstration at MPI Munich • Repeat demonstration experiment with protons with IMPROVEMENTS: • No windows • 5T Superconducting Solenoid for high acceptance • Silicon detector to measure energy directly Cryostat housing 5T solenoid.

  26. Status of Experiment • Cryostat & Magnet commissioned • Grid constructed & tested. Maintained 98KV in vacuum • Source & support structures constructed • Electronics & detectors available FWHM=250eV • Silicon Drift Detector gives excellent resolution • Thus far Fe55 X-rays

  27. Summary • Frictional Cooling is being persued as a potential cooling method intended for Muon Colliders • Simulations of mostly ideal circumstances show that the 6D emittance benchmark of 1.7x10-10 (pm)3 can be achieved & surpassed • physics/0410017 • Simulations have been supported by data from Nevis Experiment & will be tested further at the Frictional Cooling Demonstration to take place at MPI Munich • Future investigations are also on the program: • R&D into thin window or potential windowless systems • Studies of gasbreakdown in high E,B fields • Capture cross section measurements at m beams Frictional Cooling is an exciting potential alternative for the phase space reduction of muon beams intended for a Muon Collider

More Related