Common Do’s and Don’ts of Installing Network Cable

1. Common Do’s and Don’ts of Installing Network Cable In today’s world, the internet has become the prime source of information for every sector. This is why industrial cabling is not a choice anymore, it is a necessity. Almost every industry uses ethernet cable at its facility for data transmission. In case, you are setting up your company, you surely should get these cables. For the process of installing network cable, there are many things that you need to be careful about such as for starters your choice of cable is the most important thing of all. Buying ethernet cables for the entire place can turn out to be pretty expensive, therefore, you need to ensure that you only have to spend on it once. Before setting up the cables, you can go through some of the do’s and don’ts so that you prevent anything from going wrong. Check the below-given points for the same: Do’s Keep the Cable Dry and Cool When you get the cable, make sure that you keep it away from water. Everybody knows that electrical devices and water should not come in contact. Keeping the cables to a distance allows you to avoid any damage. If your cable isn’t dry, it can affect the signal as well. You can also adjust your budget to purchase the waterproof cables. Check the Cable’s Length Never forget to consider the length of the cable, regardless of which network cable you are using. Suppose you are installing the Category 6a cable, the length of the cable depends on how much area it is supposed to cover. As a customer, you must have these tiny details with you. Force stretching the cable may tear it.

2. Use the Dust Caps Your job isn’t just limited to installing the ethernet cables but also to maintain it. Those who want their cables to work effectively for a long time should keep it in good condition. You can fit dust caps into the wire so that the dust from the surrounding doesn’t get inside the cable that can lead to signal distortion. Plan for the Future Don’t think the cable you are going with today, will provide you efficiency forever. As technology advances with time, after a while, you will have to replace your existing ethernet cables with a new one that has better performance. So, fix the cables in such a way that it can be easily removed when needed like if you want to install the fiber patch cable instead of the one currently in use. Don’ts Keep the Cable near other Electrical Cables It is always suggested that you shouldn’t keep different types of electrical cables together. By placing them at close distance, you are increasing the chances of sound interferences. Having the network cables fixed near to an electrical cable will produce noise. You should also steer clear from power ripples by putting air conditioners. Use the Long Patches Further, when you set your network cable don’t connect it to a long patch. However, if it becomes necessary then you can. The reason behind this is that when you use long patches for sending signals to your multimedia outlet, you will lose its effectiveness in the entire system, plus the signal will also degrade. Overload the Cable Tray A cable tray provides a safe path for transporting the wires without causing overheating. In case, your cable tray is overloaded then you are inviting troubles. Along with disrupting the signal transmission, the cables can also fall from the tray and harm the installation. To avert it from being overloaded you can buy a cable tray that suits your cables. These are available in a variety of sizes. Bundle Up the Cables During network cable installation, don’t bundle the cables tightly. When the cables are curled up for some time, it can lose their productivity and the quality can also go down. Moreover, it can also cause issues for troubleshooting. Conclusion Before installing network cables at your office, you should explore the given points about the common do’s and don’t. By doing so, you can be certain that you have made the right choice and be efficient. For all your industrial ethernet cabling needs, visit Dintek.