DIY Steps to Fix and Repair Surfboard Ding

1. DIY Steps to Fix and Repair Surfboard Ding Surfboards are fragile and even the best professional surfers can find a crack or their surfboards. A surfboard ding is damaged the most and any living ding or crack can cause difficulties to the surfer as the board can get waterlogged in the sea. A surfer must fix the surfboard ding before getting into the water again. If not repaired over a period of time, water can cause some serious damage to the fiberglass and integrity of your surfboard. So, when you want to take your surfboard to a ding repair service, try getting it done yourself first using a ding repair kit. If you are a regular surfer, you should know basic surfboard repair methods, especially your surfboard ding. So, how can you fix your surfboard ding yourself? You don’t really need any help when it comes to repairing a minor crack or ding on your surfboard. Here’re some DIY steps to fix and repair a surfboard ding after assessing the damage. You can save a lot of time and money doing it yourself. Gather the necessary supplies and tools You can buy a complete ding repair kit or prefer buying the following items one by one: Safety mask and goggles Sandpaper Masking tape Fiberglass cloth Wax comb Knife Q-Cell Sanding resin and catalyst Acetone Paintbrush Remove the rotten or damaged area and clean it Check for the rotten or damaged areas on your surfboard and remove them properly. You need to clean the area very well in order to use the wax comb and remove any remaining wax. You may need acetone to remove some particles of wax from the rotten area. Protect the surrounding area using a masking tape It will help you protect the remaining area by containing the repair works and minimizing the sanding you need. Fill the gaps with Q-cell If there are big gaps or voids after removing the rotten area, you will need Q-cell to fill those voids. Mix the sanding resin and slowly stir in Q-Cell to make a thick paste. Add some drops of catalyst and stir again before applying on the ding area. It will serve as a replacement for the material you removed. Sand the area

2. Sand the area using sandpaper until the Q-Cell mixture gets flat in line with the board surface. Make sure that the Q-cell you applied has dried up before sanding the area. Finishing touches After sanding the Q-cell area, glass the repair using fiberglass pieces using the resign coat. Sand and apply a hot coat and then sand the area again before polishing the repair. After completing all these steps, wait for 24-48 hours to cure the repaired area. You can easily buy a ding repair kit from the market to fix your surfboard by yourself. Make sure to read the repair guide and ask for professional help if needed to avoid any further damage. Source: https://dingzap.com/