1 / 24

Small-aperture seismic arrays: instruments and detectability

Small-aperture seismic arrays: instruments and detectability. Jiří Málek, Milan Brož and Jaroslav Štrunc Institute of Rock Structure and Mechanics AS CR, Prague, Czech Republic, malek@irsm.cas.cz. Kick-off meeting Advanced Industrial Microseismic Monitoring AIM Prague 25-26.11.2009.

dana-holman
Download Presentation

Small-aperture seismic arrays: instruments and detectability

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Small-aperture seismic arrays: instruments and detectability Jiří Málek, Milan Brož and Jaroslav Štrunc Institute of Rock Structure and Mechanics AS CR, Prague, Czech Republic, malek@irsm.cas.cz Kick-off meeting Advanced Industrial Microseismic Monitoring AIM Prague 25-26.11.2009

  2. Contents • Small-aperture seismic array (SSA) for microseismic monitoring • SSA’s built by our department ( IRSM AS CR) • Optimal aperture of SSA • Linear and non-linear stacking of coherent signals Examples of studies using SSA • Converted SP waves detected at Nový Kostel array • Non-volcanic tremors in Provadia (Bulgaria)

  3. Small-aperture seismic array (SSA) for microseismic monitoring • Detection of very weak earthquakes: local shallow earthquakes M>-1.5 can be detected • Detection of (non-volcanic) tremors, recognition from industrial noise • Recognition of new phases on the seismograms of local earthquakes • Measurements of rotational components of seismic waves

  4. Small-aperture seismic array (SSA) for microseismic monitoringSpecial features: • Higher frequencies (10 – 30 Hz) • Smaller aperture • Less stations

  5. SSA’s built by IRSM AS CR • OSTA – Eastern Bohemia – Hronov-Poříčí Fault (2005) • NKCA – Western Bohemia – Seismic swarm epicentral zone (2007) • KVCA – Western Bohemia – Seismic swarm epicentral zone (2008) (now out of operation) • PROA – Provadia (Bulgaria) – Induced seismicity (2009)

  6. Nový Kostel Array (NKCA) was built around the NKC station at the main epicentral zone of the West Bohemia swarms • NKCA consists of 3 short-period three-component stations: NK1, NK2, NK3 • Distance between stations is 100 m • Registration started on Feb 22, 2007

  7. Optimal dimensions • Signals have to be coherent – small aperture • Time differences between stations should be significant – bigger aperture • Our recommendation: aperture is equal to wave-length / 4 of the typical signal V=8 km/s, F= 20 Hz => A=100 m

  8. Local event recorded at NKCA, August 8, 2007, 19:26:00.8, M = 0.7 h = 10.9 km r = 3 km P S

  9. P-wave group, NKCA, shifted seismogramsOptimal azimuth (130°) and apparent velocity (15 km/s)

  10. P-wave group, NKCA, shifted seismogramsWrong azimuth (310°) and correct apparent velocity (15 km/s)

  11. P-wave group, NKCA, shifted seismogramsCorrect azimuth (130°) and wrong apparent velocity (6 km/s)

  12. Linear and non-linear stacking of coherent signals • To determine azimuth and phase velocity f-k analysis is normally applied • Alternatively, we use optimization of stacked seismograms in time domain. • Linear or non-linear filters can be used • A new method GAS (Generalized Average Method) was developed and applied

  13. Generalized average of complex numbers p>0

  14. Generalized average of complex numbersxi = crosses, yp = dots

  15. Generalized average of signals 3

  16. Phase-weighted stack (Schimmel and Paulssen, 1997)

  17. Example 1 Identification of converted SP waves • NKCA array • Earthquake at the depth of 9.5 km • Velocity interface at the depth of 4.5 km • Intensive S-waves are generated • SP conversion is expected on Z-component between P and S onsets

  18. Searching for discontinuities above hypocenters: Converted SP wave mainly on Z component Double reflected S wave mainly on transversal component

  19. Linear stacking of seismograms (white line) for P-wave velocity, Z component SP

  20. Non-linear stacking of seismograms (white line), Z componentGAS algorithm, Malek et al., 2007 (Acta Geod. et Geom., Vol. 4, No.3) SP

  21. Example 2 Identification of tremors • PROA array (Bulgaria) • Induced seismicity from salt mines • 3 broadband sensors – GURALP CMG-40T • Local induced earthquakes • Harmonic tremors were detected (fr = 4,5 Hz)

  22. PROA array (3 stations), Z component, local induced event

  23. PROA array (3 stations), Z component, harmonic tremor

  24. Conclusions • Small-aperture seismic arrays (SSA) can be applied for microseismic monitoring of natural and induced seismicity • Non-linear filtering is a reasonable alternative to f-k analysis • Special phases on seismograms can be revealed with help of SSA • Some unusual seismic events can be recognized using SSA • We recommend to built SSA at Dobrá Voda (Little Carpathians, Slovakia) for microseismic monitoring of the region of Jaslovské Bohunice nuclear powerplant

More Related