1 / 32

Auxiliary Views

Auxiliary Views. Incline Surface Oblique Surface. By B. Cowan & R .Cash. Incline Plane. Incline plane (surface) does not appear true size in any principal views such as the Front View, Side View, or Top View.

cswearingen
Download Presentation

Auxiliary Views

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Auxiliary Views Incline Surface Oblique Surface By B. Cowan & R .Cash

  2. Incline Plane • Incline plane (surface) does not appear true size in any principal views such as the Front View, Side View, or Top View. • You must draw an auxiliary view to show the true size of an incline plane (surface).

  3. Incline Surface

  4. Incline Surface Right Side View Front View

  5. Line Of Sight Projectors Perpendicular To Incline Surface Front View Right Side View Page 271

  6. Reference Line Parallel To Edge View

  7. Aux. View

  8. Finished Drawing

  9. Auxiliary View Of A Cylinder Page 278

  10. Right Side View Front View

  11. Use Offset Command To Set Off Reference Line

  12. Project Center Line To Reference Line

  13. Project Radius Of Cylinder

  14. Use Ellipse Command To Draw Ellipse

  15. Project Bottom Of Incline Plane

  16. Use Trim Command To Trim Off Bottom Of Ellipse.

  17. Finished Drawing

  18. Partial Auxiliary Views Hidden Lines Short Break Lines Center Lines Projection

  19. General Notes Lower Right Side Of Drawing. Above Title Strip or Title Block

  20. Local Notes For Hole Size. (Other Hole Specified).

  21. Break Line Partial Bottom View Auxiliary View Edge View Of Auxiliary View General Note Local Note Partial Side View Title Strip

  22. Secondary Auxiliary View True Size of an Oblique Surface

  23. Top View 4 Oblique Surface 1 3 2 4 3 1 Step 1 Locate Oblique Surface 2 Front View

  24. Step 2 Locate True Length Lines Step 3 Draw Reference Lines perpendicular to projectors Reference Line True Length Lines Reference Line

  25. 3 4 2 1 4 3 1 3,4 2 Edge View 1,2

  26. Reference Line Reference Line

  27. 4 1 True Size 3 4 3 2 1 2

More Related