1 / 13

Engine Measuring

Engine Measuring. Vernier (Dial) Caliper. Useful because it can read inside and outside measurements. Use only as a “rough” guide. Add the reading on the blade to the reading on the dial. Micrometer. The most used measuring instrument in engine service and repair

creola
Download Presentation

Engine Measuring

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Engine Measuring

  2. Vernier (Dial) Caliper • Useful because it can read inside and outside measurements. • Use only as a “rough” guide. • Add the reading on the blade to the reading on the dial.

  3. Micrometer • The most used measuring instrument in engine service and repair • Each revolution of the thimble moves the spindle .025”. • The thimble is graduated into 25 equally spaced lines so …. • Each line represents .001”

  4. Crankshaft Measurement • Measure for out-of-round • Measure the journal in at least six different positions across the diameter at 60 degree increments. This should be done at the same horizontal position. • Subtract the highest from the lowest to factor out-of-round.

  5. Crankshaft Measurement • Crankshaft taper – measure the journal at two different horizontal positions across the journal and subtract to factor taper.

  6. Telescopic Gauge • Used in conjunction with a micrometer to determine the inside diameter of a hole. • The gauge is inserted until contact is present and then locked. • A micrometer is then used for measurement. • Use only if necessitated.

  7. Small (split)-ball Gauge • Similar to a telescopic gauge in that it is used in conjunction with a micrometer to determine the inside diameter of a hole.

  8. Small (split)-ball Gauge • The gauge is inserted until contact is present and then locked. • A micrometer is then used for measurement. • Used for small bores. • example: valve guide

  9. Split-ball Probe • More accurate than a split ball gauge • Often used for larger bores

  10. Feeler Gauge • An accurately manufactured strip of metal used to factor the gap or clearance between two components. • Used for: • Piston ring gap • Piston ring side clearance • Connecting rod side clearance • Warpage

  11. Straightedge • A precision ground metal used to check to flatness of a component. Used for: • Cylinder heads • Block deck

  12. Dial Indicator • Measures variations from zero. 14-21 • Used to check • Runout • Crankshaft endplay • Valve guide wear

  13. Dial Bore Gauge • The most accurate way to measure bore diameter, taper or out-of-round. • Gauge must be “set-up” and zeroed before usage. • Used for: • Cylinders • Main bores • Connecting rod bores • Bearing bores

More Related