using the lab pro n.
Download
Skip this Video
Download Presentation
Using the Lab Pro

Loading in 2 Seconds...

play fullscreen
1 / 8

Using the Lab Pro - PowerPoint PPT Presentation


  • 111 Views
  • Uploaded on

Using the Lab Pro. Distance Measurement Temperature Measurement. You Should Have. TI-83 in LabPro harness with short connector cable attached Power adapter connected to LabPro and plugged into outlet (it may beep at you)

loader
I am the owner, or an agent authorized to act on behalf of the owner, of the copyrighted work described.
capcha
Download Presentation

PowerPoint Slideshow about 'Using the Lab Pro' - collice


Download Now An Image/Link below is provided (as is) to download presentation

Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author.While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server.


- - - - - - - - - - - - - - - - - - - - - - - - - - E N D - - - - - - - - - - - - - - - - - - - - - - - - - -
Presentation Transcript
using the lab pro

Using the Lab Pro

Distance Measurement

Temperature Measurement

you should have
You Should Have
  • TI-83 in LabPro harness with short connector cable attached
  • Power adapter connected to LabPro and plugged into outlet (it may beep at you)
  • Vernier motion detector with cable plugged into port labeled DIG/SONIC 1 on right hand side of LabPro
setting up the lab pro
Setting up the Lab-Pro:
  • Turn on calculator - on button lower left on calculator
  • You may have to hit <clear> or <enter> button to clear out screen, leaving a blinking cursor
  • Push <apps> button ( 2nd column 3rd row)
  • Scroll down with down arrow button till you see :DataMate then
  • Push enter button (lower right) and wait
your screen will look like this
Your screen will look like this

DIG1:MOTION(M) #.##

MODE: TIME GRAPH-5

==========================

1:SETUP 4:ANALYZE

2:START 5:TOOLS

3:GRAPH 6:QUIT

(#.## should read a number – this is your distance measurement)

slide5
Unit may signal “Checking Sensors” before it shows the correct sensor and screen.
  • Press clear to reset (just below arrow keys) and wait for screen to reappear.
  • Unit is now measuring distance continuously.
slide6
Done?
  • When you’re done, hit the <6> key to quit, then hit <enter>. You should be back at the blank screen with blinking cursor.
change probes
Change Probes
  • Quit the program per the last slide
  • Disconnect the ultrasonic cable from the unit.
  • Connect the temperature probe on the opposite side of the unit
  • Get back into apps / Datamate per slide 3
  • Let unit cycle while it figures out which probe it has
  • If successful, temp. is now shown.
your screen will look like this1
Your screen will look like this

CH1:TEMP(C) 22.1

MODE: TIME GRAPH H20

==========================

1:SETUP 4:ANALYZE

2:START 5:TOOLS

3:GRAPH 6:QUIT

This is your temperature in degrees Celsius

ad