1 / 10

Figure 7.1 The basic MOS differential-pair configuration.

Differential Amplifiers. Why differential? • Well suited for integrated circuit (IC) fabrication • Less sensitive to noise • Possibility to couple amplifier stages without capacitors. Figure 7.1 The basic MOS differential-pair configuration. Operation with a Common-Mode Input Voltage.

caradoc
Download Presentation

Figure 7.1 The basic MOS differential-pair configuration.

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Differential Amplifiers Why differential? • Well suited for integrated circuit (IC) fabrication • Less sensitive to noise • Possibility to couple amplifier stages without capacitors Figure 7.1 The basic MOS differential-pair configuration.

  2. Operation with a Common-Mode Input Voltage Figure 7.2 The MOS differential pair with a common-mode input voltage vCM.

  3. Operation with a Differential Input Voltage Figure 7.4 The MOS differential pair with a differential input signal vid applied. With vid positive: vGS1>vGS2, iD1>iD2, and vD1<vD2; thus (vD2-vD1) will be positive. With vid negative: vGS1<vGS2, iD1<iD2, and vD1>vD2; thus (vD2-vD1) will be negative.

  4. Large-Signal Operation Figure 7.5 The MOSFET differential pair for the purpose of deriving the transfer characteristics, iD1 and iD2 versus vid=vG1 – vG2.

  5. Figure 7.6 Normalized plots of the currents in a MOSFET differential pair. Note that VOV is the overdrive voltage at which Q1 and Q2 operate when conducting drain currents equal to I/2.

  6. Figure 7.7 The linear range of operation of the MOS differential pair can be extended by operating the transistor at a higher value of VOV.

  7. Small-Signal Operation of The MOS Differential Pair Differential Gain Figure 7.8 Small-signal analysis of the MOS differential amplifier: (a) The circuit with a common-mode voltage applied to set the dc bias voltage at the gates and with vid applied in a complementary (or balanced) manner. (b) The circuit prepared for small-signal analysis.

  8. Common-Mode Gain and Common-Mode Rejection Ratio Figure 7.10(a) The MOS differential amplifier with a common-mode input signal vicm. (b) Equivalent circuit for determining the common-mode gain (with ro ignored). Each half of the circuit is known as the “common-mode half-circuit.”

  9. The BJT Differential Pair Figure 7.12 The basic BJT differential-pair configuration.

  10. Figure 7.14 Transfer characteristics of the BJT differential pair of Fig. 7.12 assuming a. 1.

More Related