1 / 19

Modelling and simulation of hydraulic motor tribology

Modelling and simulation of hydraulic motor tribology . Patrik Isaksson. Agenda. Introduction Mixed lubrication model Test rig-validation Micro EHL Tribology modeling - Project leakage reduction. Introduction-tribological interfaces. Piston assembly Distributor plate Seals

Download Presentation

Modelling and simulation of hydraulic motor tribology

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Modelling and simulation of hydraulic motor tribology Patrik Isaksson

  2. Agenda • Introduction • Mixed lubrication model • Test rig-validation • Micro EHL • Tribology modeling - Project leakage reduction

  3. Introduction-tribological interfaces • Piston assembly • Distributor plate • Seals • Rolling element bearings • …

  4. Tribology of hydraulic motor • Wide speed and load range • High loads-EHL • All lubrication regimes has to be considered

  5. Modellingtribology of hydraulic motors • Fluid dynamics • Thin film approximation of Reynolds equation is used • Structural deformation • High loads • Fluid property model • Viscosity dependence • Surface roughness • -when film thickness is small

  6. Mixed lubrication-modelling strategy • Separate the problem into two different scales • Local scale representing surface roughness • Global scale representing the piston bearing structure • Deformation is calculated on both scales Local scale Global scale

  7. Mixed lubrication model • Modified Reynolds equation • Incorporating the effects of the local scale fluid flow through flow factors

  8. Mixed lubrication model-friction calculation • Friction is calculated as the sum of friction from asperity contact and hydrodynamic friction

  9. Simulation software • Commercial software package-COMSOL • Based on finite element method • Facilitates flexibility as a design tool • Fluid dynamics and other needed equations can easily be implemented • Full system solution approach

  10. Test rig-validation • Friction, leakage and oil film pressure is measured in the roller-piston interface

  11. Validation-modeling test rig setup • Mixed lubrication model applied in roller/piston interface

  12. Validation-Oil film pressure

  13. Validation-Leakage

  14. Validation-mixed lubrication Movie clip

  15. Lift off zone Not always very good correlation, some effect and/or input is missing

  16. Micro EHL Deterministic EHL model of high pressure zone with transverse ”roughness”

  17. Micro EHL Micro EHL will influence transition between full film and mixed/boundary

  18. Tribology modeling - Project leakage reduction Task: • Reduce leakage in piston to 50% • Keep low friction

  19. Project leakage reduction-result • New piston design in production

More Related