Power Problems That Can Harm Your Diagnostic Imaging Equipment

1. Power Problems That Can Harm Your Diagnostic Imaging Equipment Sensible Solutions for Refurbished Radiology By: Vikki Harmonay

2. One of the biggest concerns about owning diagnostic imaging equipment is its susceptibility to power problems.power problems These can be massive events, like total power failures and lightning strikes, or they can be caused by surges, swells, brownouts, sags, spikes or small flickers. However, if you understand the different kinds of power problems your medical equipment can be exposed to, you can identify and prevent potential problems. The last thing you want to do is take a wait-and-see stance and face large repair bills, glitches during procedures or even have to cancel patient appointments. Sensible Solutions for Refurbished Radiology

3. What Is A Flicker? • A flicker is a momentary power outage that causes a brief service interruption. It usually lasts 60 seconds or less. A flicker can shut down electronic devices and appliances in your facility.. Sensible Solutions for Refurbished Radiology

4. Flicker can be caused by: • Tree branches making contact with a power line • Accidents involving vehicles and electrical equipment • Lightning strikes • Accidents at construction sites involving power lines • Electrical Company equipment being affected by salt spray or extreme weather • Damage to underground equipment Sensible Solutions for Refurbished Radiology

5. What Is a Surge? • A surge is a rapid short-term increase in voltage. These are often caused by unexpected burdens on an electrical system (like lightning) during which a brief but intense increase in the amount of electricity happens. A surge can also happen when high power demand devices (like air conditioners) turn off and the extra voltage is dissipated through the power line). Sensitive electronic devices need a constant voltage, so a surge can stress delicate components and cause premature power failures. Sensible Solutions for Refurbished Radiology

6. What Is A Spike? • A spike is when an extremely high increase in voltage happens in a very short duration that’s measured in microseconds. They are often caused by lightning, when power comes back on after an outage. Spikes can damage or even destroy sensitive electronic equipment. That’s why electronic equipment should be turned off during a power outage. Be sure not to turn the power on again until a few minutes after power is restored. Be sure to turn on one device at a time. Sensible Solutions for Refurbished Radiology

7. What Is A Swell? • A swell is a short-term increase in voltage which can lead to stressed or damaged electronic components. This can cause premature equipment failure. Sensible Solutions for Refurbished Radiology

8. What Is A Sag? • A sag is also referred to as a brownout. It’s a rapid short-term decrease in voltage which it usually caused by the simultaneous high power demand of many electrical devices like compressors, motors, etc. The effect of a sag starves electronic equipment of power which causes unexpected crashes and the loss of corrupted data. Sags can also reduce the efficiency and life span of equipment like electric motors. Sensible Solutions for Refurbished Radiology

9. What Is Noise? • Noise is a disturbance in the smooth flow of electricity which is referred to as electromagnetic interference (EMI) or radio frequency interference (RFI). It can be caused my electronic devices and motors in the immediate vicinity or far away. Noise affects the performance of some equipment and introduces glitches and errors into data files and software programs. Sensible Solutions for Refurbished Radiology

10. What Is An Outage? • An outage is also referred to as a blackout. It’s a total loss of power for a period of time. They are usually caused by excessive demands on a power system, accidental damage to power lines and even lightning strikes. Outages can also cause unexpected data loss. A partial power outage—when the power goes out in only part of a facility—can be caused by a blown fuse, a tripped circuit breaker or a broken connector or wire at one of the service leads to a building. Sensible Solutions for Refurbished Radiology

11. What Kind Of Power Issue Am I Experiencing? • Electrical Equipment Issues: Most likely a surge or a spike • Air Conditioning Interruption: Sag, flicker or well • Flickering Lights: Probably a sag, swell or flicker • Shrunken TV or computer picture: Sag • Computer Turning Off And On: Flicker • No Electricity In Entire Facility: Power Outage • No Electricity In One Room: Partial power outage Sensible Solutions for Refurbished Radiology

12. Talk to An Expert • Are you having issues with your medical imaging equipment? Is it time to upgrade your CTScanner, C-Arm  or MRI? Chances are, you can get the performance you want at a much lower price by choosing a refurbished or used system. Atlantis Worldwide has been helping healthcare facilities like yours with their medical imaging needs for almost 30 years. We’d love to help you. • Contact Us Today! • Follow Atlantis Worldwide on Twitter: @AtlantisLLC Sensible Solutions for Refurbished Radiology

13. Some blogs you may have missed: • Reduce The Costs of Your Medical Imaging Equipment & Services • Installing a CT Scanner: What You Need to Know • Should your business lease or buy medical imaging equipment? • The Benefits of Renting a C-Arm • Free Resources Sensible Solutions for Refurbished Radiology

14. You can read this on our website • https://info.atlantisworldwide.com/blog/comparing-cannon-aquilion-ct-scanners Sensible Solutions for Refurbished Radiology

15. Contact Us 200 Park Avenue, Suite 1752 New York, NY – 10166, USA Phone: 1-212-366-9100 Toll Free: 1-800-533-3356 Fax: 646-762-6562 info@atlantisworldwide.com https://www.atlantisworldwide.com https://info.atlantisworldwide.com/blog Sensible Solutions for Refurbished Radiology