1 / 9

Background simulation for 35-ton data

This project aims to develop a realistic background simulation for the 35-ton data in order to understand its effects on signal reconstruction. It will include accurate descriptions of background level, time correlations, channel correlations, and variations. The effect of background removal on signal reconstruction will also be studied.

athey
Download Presentation

Background simulation for 35-ton data

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Background simulation for 35-ton data DUNE 35-ton simulation and reconstruction David Adams BNL October 5, 2016

  2. Introduction Like to have realistic BG simulation for 35-ton • Want to understand the effect of BG on signal reconstruction • Can measure this directly if we know the true signal • Need accurate description of the background • Level • Time correlations (frequency spectrum) • Channel correlations • Run-to-run and event-to-event variations in all the above • Effect of BG removal on signal reconstruction • Expect channel-coherent noise removal to have a big effect on the signal • Can be studied without BG but BG will change the removal estimate Redmine ticket created asking for this BG simulation • https://cdcvs.fnal.gov/redmine/issues/14082 • Thanks to Matt for putting this in • And to him and Dom (and me) for contributing to discussion thus far • More ideas and design/code welcome D. Adams, BNL DUNE FD sim/reco BG simulation October 5, 2016

  3. Ideas Correlations • There are two types of BG correlations • Coherence: correlation between time bins • Leads to frequency spectrum that is not flat • Correlation: channel-to-channel correlations • Add systematic biases in charge measurements between channels (bad) • BG in one channel can be estimated (and then removed) using the signals from other channels (good) • Signal pollution • I will try to stick with this naming convention (coherence vs. correlation) Two approaches being considered • Direct simulation of the noise • Take noise from the data Following slides consider each separately • Do we want one or both? • Discussion encouraged D. Adams, BNL DUNE FD sim/reco BG simulation October 5, 2016

  4. Example noise plots First some example noise frequency plots • From my talk last week • For one “typical” collection and induction channel for one event • I only looked carefully at about 50 channels in the one event • Clearly need a more comprehensive survey before drawing too many conclusions • Observe that correlated noise removal decreases BG by about 50X • But coherent BG is still about 50X above incoherent •  Both coherence and correlation are very important D. Adams, BNL DUNE FD sim/reco BG simulation October 5, 2016

  5. Collection example Even with NR, coherent BG dominates. Incoherent BG: 200 (ADC count)2 corresponds to 4.5 (ADC count)/tick D. Adams, BNL DUNE FD sim/reco BG simulation October 5, 2016

  6. Induction example Same comments as for collection. D. Adams, BNL DUNE FD sim/reco BG simulation October 5, 2016

  7. Direct noise simulation Progressively sophisticated simulation of noise • Get the right level (RMS) using incoherent and uncorrelated noise • Request from Mark last week • Add (time) coherence • I.e. get approximately correct frequency spectrum • Is existing ExponentialChannelNoiseService sufficient? • Do we need more than nearest-neighbor correlations (red/pink noise)? • Add channel correlations • Need these because they are used in noise removal which is likely distorting signals • Requires new service and likely change/addition of interface D. Adams, BNL DUNE FD sim/reco BG simulation October 5, 2016

  8. Data-driven noise estimates Take noise from data • I.e. overlay raw data from 35-ton on simulated signal • BG includes both electronic noise and cosmic signals (good?) • So typical signal would be a single muon (or other particle) Want background to be unbiased (or minimally biased) • Scintillator triggers occur in ticks 4000-5000 or 5000-6000 • Depending on run • Do we have any events with unbiased trigger? • E.g. random or accidental • Can we use channels 7000-15000 in scintillator-triggered events? • MC data would have smaller window (8k vs. 15k ticks) that data • OK for most/all studies? • Alternative is to look for events with tick ranges that show no evidence of signal • Then BG would not include cosmics—use this with full cosmic simulation • E.g. if someone wants to use 35-ton to measure cosmic flux D. Adams, BNL DUNE FD sim/reco BG simulation October 5, 2016

  9. The end D. Adams, BNL DUNE FD sim/reco BG simulation October 5, 2016

More Related