1 / 10

Chelmsford Amateur Radio Society M3 Foundation Course Transmitters & Receivers

Chelmsford Amateur Radio Society M3 Foundation Course Transmitters & Receivers. Tuned Circuits. Radios depend on the concept of tuned circuits. Tuned circuits are built from combinations of Inductors and Capacitors which have a self-resonant frequency.

atara
Download Presentation

Chelmsford Amateur Radio Society M3 Foundation Course Transmitters & Receivers

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Chelmsford Amateur Radio Society M3 Foundation CourseTransmitters & Receivers

  2. Tuned Circuits • Radios depend on the concept of tuned circuits. • Tuned circuits are built from combinations of Inductors and Capacitors which have a self-resonant frequency. • Tuned circuits are thus able to selectively pass or block frequencies in transmitters and receivers. • They are the basis of tuners, filters, oscillators, ATUs etc.

  3. 1 2 4 Mic 3 Transmitters • Transmitter concept is in the block diagram below:- • Foundation Licence only permits use of commercial equipment to minimise the risk of interference and/or out-of-band operation. • Avoid over-deviating, and operating PAs into poor matches !! 1 - Audio Stage 2 - Modulator eg AM, FM, SSB 3 - RF Frequency Generator 4 - RF Power Amplifier

  4. 3 1 2 4 Receivers • Receiver concept is in the block diagram below:- • RF Front end is critical to performance. Inductors and capacitors create selectively tuned circuits. • RF Amplifier stage dominates the Noise performance • Detection circuits for decoding AM, FM etc are different 1 - Tuning and RF Amplifier 3 - Audio Amplifier 2 - Detection 4 - Loudspeaker

  5. v vm/s f fHertz metres  Modulation • Modulation (or Mode) refers to how audio or data information is superimposed onto an RF ‘Carrier’ frequency • Remember - the RF Carrier is a sine wave:-

  6. Audio Input RF Carrier AM Signal AM Modulation • AMPLITUDE MODULATION (AM) - The audio signal varies the amplitude of the RF Carrier • Note if Audio is too strong, clipping and distortion occurs • Simple AM gives carrier with lower and upper sidebands

  7. Audio Input RF Carrier FM Signal FM Modulation • FREQUENCY MODULATION (FM) - The audio signal varies the Frequency of the RF Carrier - its Amplitude stays constant • Actual amount of variation is small & called Deviation • Signal Amplitude is constant and doesn't carry info. It’s therefore less prone to interference

  8. Keyer /Data CW Signal FSK Signal CW & FSK Modulation • Morse, also called CW, is the simplest form of digital mode. • FSK, Frequency Shift Keying, is used for higher speed ‘Packet’ data • Poor Edges can give ringing or key clicks • Don't overdrive if TNCs used for Packet Data • Data rates are limited by available Bandwidth

  9. Earthing/EMC • Good reception especially on HF, as well as EMC performance, depends on good earthing. • Ensure shack equipment is run from a common mains earth to prevent earth loops - use filtered mains boards and ferrite rings correctly. • RF Earths for antennas are often separate - consider earth stakes etc. • Modern Gas & Water Pipes can give high resistance earth. • AM/SSB can be rectified/detected easily, so is most prone to cause interference - Operate in a responsible manner!

  10. Operating Precautions • Ensure Transmitter frequencies/modes are setup correctly so emissions are always in band, and conform to bandplans. • RF power amplifier outputs must be connected to a correctly matched antenna to work properly. Use of the wrong antenna can result in damage to the transmitter. • Excessive AM modulation or FM deviation will cause distorted outputs, and interference on adjacent channels • Ensure that Microphone Gain (where fitted) is correctly adjusted

More Related