1 / 34

ANCHORAGE

ANCHORAGE. Critical Parameters. Bolt Type Strength Grade Diameter Length Density (spacing) Plates. Bolt Length. Industry Rule Of Thumb: Bolt length should be half the supported span dimension. Bolt Length. Bolt Density. 1’. Anchorage 1 Ton/Ft (1 Ton). Anchorage 10 Tons.

arleen
Download Presentation

ANCHORAGE

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. ANCHORAGE

  2. Critical Parameters • Bolt Type • Strength • Grade • Diameter • Length • Density (spacing) • Plates

  3. Bolt Length Industry Rule Of Thumb: Bolt length should be half the supported span dimension.

  4. Bolt Length

  5. Bolt Density

  6. 1’ Anchorage 1 Ton/Ft (1 Ton) Anchorage 10 Tons 10’ FRICTION ANCHORED SUPPORT POINT ANCHORED SUPPORT

  7. Bolt Density

  8. Fall of splitset supported back in an underground limestone mine

  9. Bolt Length

  10. Failure of Mechanical Bolts

  11. Installation Angle ?

  12. Installation Angle Install Bolts Perpendicular to the Rock Surface for Pattern Bolting (Except Where Key Block Bolting is Required)

  13. Pattern Bolting versus Spot Bolting

  14. Resin Anchored Bolts Primary Support Friction Anchored Bolts Surface Control

  15. Bolt Across Joints

  16. Bolt Perpendicular To Joints

  17. SURFACE CONTROL PLATES, CHANNELS & MATTS

  18. GRADES OF PLATES K2, K3 & K4 2 = 20,000 LBS K = LETTER DENOTES NAME OF MANUFACTURER

  19. Donut Bearing Plate Donut Header Plate

  20. 8” x 8” Bearing Plate 6” x 10” Low Profile Header Plate 6” x 16” Low Profile Header Plate

  21. 6” x 6” Flat Plate 6” x 16” Low Dome Header Plate 4” x 9” Channel Plate

  22. 6” x 6” Dome Plate 6” x 6” SAF Dome Plate

  23. MATSUSED TO CONTROL ROOF SLOUGHING

  24. PIZZA PANS

  25. CHANNELSUSED THE SAME AS A CROSSBAR FOR ROOF CONTROL

  26. TENSAR W/WO BACKING

  27. Plate Size Size and Type of Bearing Plate Should Correspond to Ground Conditions

  28. Soft Rock Skin Weak Rock

  29. Small Plate (Covers Less Area) Damage to Surface Large Plate (Covers More Area) Less Damage to Surface Large Plate (Covers More Area) Less Damage to Surface Small Plate (Covers Less Area) Damage to Surface Soft Rock Skin

  30. Back Overstressed (Rock Falls Out) Loose Plate-No Tension Back Overstressed (Rock Falls Out) Loose Plate-No Tension Soft Rock Skin

  31. PROPER INSTALLATION REQUIRES CORRECTLY DRILLED HOLES Too Short Loose Plate Too Long Short Grout Length Too Small Insertion Problems Too large Less Anchorage Hole Length ( Resin Systems) Hole Diameter

More Related