1 / 9

Distance, Time, and Speed

Distance, Time, and Speed. Speed. Variable – A quantity that can change, often with a numerical value. A variable has a name and a value. Examples – speed, depth, time, etc. Speed. Speed is the relationship between distance and time. v = d/t. Conversion Factors.

abram
Download Presentation

Distance, Time, and Speed

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Distance, Time, and Speed

  2. Speed • Variable – A quantity that can change, often with a numerical value. A variable has a name and a value. Examples – speed, depth, time, etc.

  3. Speed • Speed is the relationship between distance and time. • v=d/t

  4. Conversion Factors • You can’t compare values in different units. Must change into the same units. • Practice #1 – Convert 32km/hour to m/s • Practice #2– Convert 595m/s to km/hr • Practice #3– Convert 45mi/hr to m/s • 1 mile = 1.609km

  5. Speed vs. Velocity • Velocity is the same as speed, EXCEPT there is a direction associated with it.

  6. Solving Problems • What is the average speed in km/hr of a car that has traveled 17 meters in 3 seconds? • How far did a car travel in 3 hours that had a constant speed of 50 km/hr? • How long did it take a car with a constant speed of 70 miles/hour to travel 600 miles?

  7. Accuracy and Error • Error is the difference between a measurement and the true value. • Accuracy is how close a measurement is to the true value.

  8. Error • Assume the average is the “true value”. • The error is the difference between the average and the highest and lowest values.

  9. Error Practice Problems • If the width of a machine part should be 4.00cm with an acceptable error of +/- 0.03cm, which of the following lengths is significantly different? A. 4.04cm B. 3.98cm C. 4.29cm Given the same information above, which of the measurements is within the accepted amount of error?

More Related