Safe Use of Geared Trolleys!

1. Safe Use of Geared Trolleys! Very often users remove the blocks from trolleys for storage purpose and leave them behind. Geared trolleys are subjected to corrosion and damage, therefore, are supposed to be protected for them. When one is required to remove the trolleys for separate storage, consider these vital aspects. Do not return a damaged trolley to the storage. They need to be dried and cleaned thoroughly in order to prevent their corrosion. Storing geared trolleys in a dry and clean area will protect them for damage. To avoid further damage, the operating chains, pendant power controls etc. are required to store separately with clear labeling and cautious removal. Trolleys should not be dropped or thrown down. Dos’: •Correctly handle and store the trolleys. •Thorough inspection of the trolleys, blocks, and accessories is must before you begin their use and before you place them in storage. •The wheel profile needs to be accurate to make it suitable for the track. •Check whether the width of trolley is accurate for the track or not. •Fit the track with positive end stops. •Rather than pushing pull loads suspended on push/pull trolleys. Don’ts: •Without prior consultation from supplier don’t expose trolleys to chemicals, particularly acids. •Forcing the suspension hook of blocks onto the load bar can cause damage. •Throw or drop a trolley. •Direct exposure to water sprays and atmosphere with high moisture content. •Use a trolley with damaged wheel flanges. •Obliquely side loads a trolley. Using trolleys safely: Depending on the requirements of the blocks with which it is to be used one should make safe use of geared trolleys, one should take the following in consideration: Usage of defective trolleys, blocks, and other accessories can lead to disaster at worksite. Put the trolley directly over the gravity of the load and not obliquely side.

2. Overload can cause damage to the track as it will cause the trolley to tip over and fall off track. Avoid swinging loads in the case of push/pull trolleys by pushing rather than pulling of suspended loads. Installing and commissioning: Follow the specific instructions provided by the supplier during the installation of the trolleys. These are attached or pasted along with the body of the trolleys and must be read carefully. Pay attention to the following while their use and inspection: For the safe use of geared trolleys make sure that the track is at level and has an even running surface. It must be fitted with positive end stops that engage with the trolley frame or wheel treads. The trolley needs to be set correctly to the width with spacers equally disposed about the center line. The wheel needs to be suitable for the track and anti-tilt devices are to be set. Saudi Dutest is one of the leading beam clamp suppliers in the UAE and onewill find variety of lifting equipment and relevant accessories that help run your business and projects smoothly.