E N D
Sun Air HVAC Sun Air HVAC Steps To Safely Light a Pilot Light In a Furnace You can find the instructions label on your furnace. Every furnace should include a label that instructs you on how to light it. However, the printing may be too small at times, or the furnace service Sacramento, CA area may be too dark. The label may be difficult to read in some instances. The work will be considerably easier if you keep the following instructions near your furnace or in another safe place where they may be easily found. Locate Pilot lights and components A switch near the bottom of your furnace repair Sacramento usually says “Pilot,” “On,” and “Off.” Locate this switch and flip it to the “Off” position. Wait at least five minutes before proceeding. This is significant because it allows the gas to disperse, which is required to avoid fire. While you’re waiting, note where the reset button is, which should be close to the dial you just switched off. Reactivate the light pilot Turn the knob to “Pilot” after the gas has dissipated. Then press and hold the “Reset” button while bringing a lighter’s flame close to the pilot light opening. This should light the pilot light on the furnace. Once you’re certain the pilot light is turned on, let go of the reset button. To get you started, some important points are mentioned below that will walk you through the procedure of re- lighting a pilot light and you can avoid calling professionals for HVAC in Sacramento, CA.