1 / 8

5 steps to reset brostrend wifi extender

To reset a Brostrend WiFi extender, first, locate the small reset button on the back of the device, which may be labeled u201cResetu201d or hidden in a tiny hole. Using a paperclip or pin, press and hold this button for about 10-15 seconds. As you hold the button, the LED lights on the extender will begin to flash, signaling that the reset process has started. Once the reset is complete, release the button and wait for the extender to reboot.

Eric179
Download Presentation

5 steps to reset brostrend wifi extender

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. 5 STEPS TO RESET BROSTREND WIFI EXTENDER EXTENDER 5 STEPS TO RESET BROSTREND WIFI

  2. STEP 1 LOCATE THE RESET BUTTON Find the small Reset button on the Brostrend Wi-Fi extender. It’s usually located on the back or bottom of the device.

  3. STEP 2 PRESS AND HOLD THE RESET BUTTON Use a paperclip or pin to press and hold the Reset button for about 10–15 seconds. You’ll notice the LED lights on the extender blinking or turning off during this process.

  4. STEP 3 RELEASE THE BUTTON After holding the reset button for the required time, release it. The extender will reboot, and the factory reset process will start.

  5. STEP 4 WAIT FOR THE REBOOT Allow the extender a few minutes to fully reset and reboot. The LED lights will usually flash and then stabilize once the reset is complete

  6. STEP 5 RECONNECT AND SET UP AGAIN Once the reset is done, the Wi-Fi extender will be restored to its default factory settings. You'll need to reconnect to it and set it up again using the default Wi-Fi settings (SSID and password) listed on the device's label or in the manual.

  7. FOR ANY QUARY VISIT US https://brosstrend.com/

  8. THANK YOU

More Related