1 / 6

GPS-VTI

GPS-VTI. by Tony Barry presented by Dave Gault. Overview. minimal wiring (less than thirty wires to solder) no chips, transistors, or surface mount to solder. Just wires + LEDs + switch. doesn't need USB to function, can run off 12V DC based on Arduino AVR architecture (MEGA1280).

vin
Download Presentation

GPS-VTI

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. GPS-VTI by Tony Barry presented by Dave Gault

  2. Overview • minimal wiring (less than thirty wires to solder) • no chips, transistors, or surface mount to solder. Just wires + LEDs + switch. • doesn't need USB to function, can run off 12V DC • based on Arduino AVR architecture (MEGA1280). • uses Sparkfun breakout board for MAX7456 • GPS is EM406A from USGlobalSat • Add - two LEDs, one switch, two RCA sockets, a case and an afternoon to assemble • code is open source released under “Berkeley 3-clause software licence”

  3. The circuit diagram

  4. The setup screen

  5. The timing screen HHMMSS milliseconds Vsync period field counter field end

  6. Summary • Cost ~$100 and an afternoon with a soldering iron • Software to load the program into the microcontroller is free • Code is still in development, currently at beta v16 • Independent QA review is yet to be arranged • Should have a second device ready for testing in the new year usage is relatively simple. • Connect to camera, monitor, 12V or USB port of laptop - power on • Switch to "Setup“ • Wait for GPS fix (may take a few minutes) • record observer’s site details • Switch to "Run" • Wait for 10 seconds for the GPS’s ZDA mode to start • Record the occultation.

More Related