Hofmann Alignment Adjustment Features Training A-ARM Adjustment . Why would the Technician want to make an adjustment?. Low Caster on right side and High Camber on right side resulting in a Pull condition to the Right.
Alignment Adjustment Features
Why would the Technician want to make an adjustment?
Low Caster on right side and High Camber on right side resulting in a Pull condition to the Right.
This Screen is indicating to move the front of the Upper A-Arm in, and the rear of the Upper A-Arm in
Select the Jack icon to Toggle from Elevated or Turntable adjustment
If the adjustments are on the Lower Control Arm, Click on the icon to Toggle to the Lower A Arm
It would now be necessary to move the Lower A-Arm out at the front and out at the rear
As you move the A-Arm, in the indicated direction, the scale will move towards the center.
This screen shows the left side adjustment
Because the left side is near desired, the Technician may skip past the left side adjust screen by clicking on the green icon
Caster and Camber adjustments will normally change the Toe setting. It will now be necessary to adjust the Toe
A-Arm adjust mode will use the preferred specification as the desired end result.
If a setting other than preferred is desired, edit the specifications and make the desired setting the preferred
Caster and Camber set to factory preferred
Preferred Caster and Camber altered to help offset road crown pull