TDI Hardwood Floors offers hardwood flooring, hardwood floor repairs, hardwood flooring installation, refinishing, dustless sanding in Victoria BC. Visit: http://www.tdihardwoodfloors.com/
How to Refinishing Hardwood Floors?
HardWood Floor Refinishing
1. Good dirt masks. Rent an honest tools that have dustless refinishing system.
2. Main electric sander, this could be a sander electric power tool or belt sander.
3. Edger that is to surface the sides, near the wall.
4. Buffer for the ultimate sleek sanding of you hardwood floors.
5. Sand paper for every machine. For a little sleeping room get 40 grit sixty grit eighty grit 100 grit for the most electric sander, get just one of every grit, for the edger identical grits however you’ll would like five discs of every grit. If the provider is shut you’ll be able to forever get a lot of if you wish it, the utilization of the sandpaper depends on the end that has been used on the hardwood floors. Some hardwood floors are painted. If you’d wish to surface painted hardwood floor confirm you get lots of paper. it’s not suggested to sand paint since most of the paints can cause metastasis issues once sanded.
6. One 150 buffer screen and one 180 buffer screen.
8. Sealer, finish, brush and end applier.
You can rent those tools and also the native rental tools place. In Victoria, BC particularly you’ll be able to notice couple places in telephone book.
2. You will use the most electric sander initial mistreatment forty grit, confirm to sand wooden flooring with the grain(run the sanding machine identical direction that boards run)
3. Make sure you’re sanding steady, do not stop with the electric sander operating.
4. Main electric sander won’t get near the walls, this can be wherever you’ve got to use edger. Use identical grit that is 40.You can take of the baseboards and install them back when the eating is finished. If you do not need to put in baseboards you can need to be terribly careful to not bit baseboards with the edger and so will need to manually scrape the unhanded space near the baseboards
5. Sand with main electric sander with 60 grit afterward edger once more with 60 grit.
6. Repeat the method mistreatment the 80 grit.
7. Reset the nails
8. Vacuum the ground very well. Apply the wood filler with an out sized spatula.
9. Wait associate till wood filler is dry. Drying time are completely different relying wherever you’re, after all in hot climate like Victoria, Vancouver at the new sunny day when one hour filler is dry and wooden flooring able to sand once more.
10. Sand off the filler with 100 grit. If the filler failed to came off fully when one cut, sand floors an additional time.
12. Vacuum sanded hardwood floor well. confirm at this time to stay the ground dry and clean.
13. Using buffer sand with 150 grit.
14. Vacuum once more and sand with 180 grit.
15. Vacuum once more very well.
16. Apply hardwood floor sealer wait till dry.
17. Apply two coats of end, follow manufacturer directions.
This is an easy means of refinishing hardwood floors.
Address: 2845 Acacia Drive,Victoria, B.C. ,V9B 5A2, Canada
Email Id:[email protected]