hvac214 electrical for oil
Download
Skip this Video
Download Presentation
HVAC214 – Electrical for Oil

Loading in 2 Seconds...

play fullscreen
1 / 11

HVAC214 – Electrical for Oil - PowerPoint PPT Presentation


  • 79 Views
  • Uploaded on

HVAC214 – Electrical for Oil . Fan Centers. Fan Centers. Designed to provide low voltage control of blower motors and auxiliary circuits. Provide a good junction point for other circuits. Used on heating, cooling and air conditioning systems. Fan Centers. Contain:

loader
I am the owner, or an agent authorized to act on behalf of the owner, of the copyrighted work described.
capcha
Download Presentation

PowerPoint Slideshow about ' HVAC214 – Electrical for Oil ' - tanith


An Image/Link below is provided (as is) to download presentation

Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author.While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server.


- - - - - - - - - - - - - - - - - - - - - - - - - - E N D - - - - - - - - - - - - - - - - - - - - - - - - - -
Presentation Transcript
fan centers
Fan Centers
  • Designed to provide low voltage control of blower motors and auxiliary circuits.
  • Provide a good junction point for other circuits.
  • Used on heating, cooling and air conditioning systems.
fan centers1
Fan Centers
  • Contain:
    • a low voltage transformer (step down from 120 to 24 volts)
    • Has a multifunction switching relay
    • Low voltage terminal board.
fan centers2
Fan Centers
  • Sometimes used when there are two transformers, one on the heating and one on the cooling side. These transformers must be isolated based on what the system is doing.
fan centers3
Fan Centers
  • These notes are based on the Figure 2, on page 2 of the Tradeline manual attached to your notes.
  • This is a diagram of a heating and cooling application with a two speed fan.
    • Cooling high speed
    • Heating low speed
fan center1
Fan Center
  • Connections:
    • W is the junction point for W from tstat and W from equipment
    • G is the connection from G from the thermostat
    • Y is a junction point from for Y from the t-stat
    • C is common from internal transformer
    • R is power from internal transformer
fan center2
Fan Center
  • In a call for heat the normally closed relay to the blower is closed and the fan is controlled by a secondary switch in the furnace plenum.
  • In a call for cool, green is energized and brings the fan in on high speed.
fan center3
Fan Center
  • The W, Y, and any additional terminals are just junction points.
  • Remember, transformers in series double the voltage.
  • Transformers in parallel double the amperage available.
fan center4
Fan Center

Burner Control

R

L1 ---->

G

Fan High

Y

Fan Limit

Then Fan Low

W

Tstat

(opt)

Condenser

ad