1 / 48

Starting point: Langmuir’s OML theory

Starting point: Langmuir’s OML theory. No integration necessary; very simple formula for ion current. This requires very small R p / l D , so that there is no absorption radius. UCLA. Post-Langmuir probe theories - 1. Sheath, but no orbiting. UCLA. Post-Langmuir probe theories - 2. UCLA.

tadhg
Download Presentation

Starting point: Langmuir’s OML theory

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Starting point: Langmuir’s OML theory No integration necessary; very simple formula for ion current. This requires very small Rp / lD, so that there is no absorption radius. UCLA

  2. Post-Langmuir probe theories - 1 Sheath, but no orbiting UCLA

  3. Post-Langmuir probe theories - 2 UCLA

  4. Post-Langmuir probe theories - 3 UCLA

  5. Post-Langmuir probe theories - 4 UCLA

  6. Probes in fully ionized plasmas

  7. Experimental verification in Q-machine - 1 UCLA

  8. Experimental verification in Q-machine - 2 Such nice exponentials were never seen again! UCLA

  9. Experimental verification in Q-machine - 3 UCLA

  10. Problems in partially ionized, RF plasmas • Ion currents are not as predicted • Electron currents are distorted by RF • The dc plasma potential is not fixed Getting good probe data is much more difficult! UCLA

  11. Ion currents in an ICP discharge They fit the OML theory, which is not applicable! UCLA

  12. Each theory yields a different density • Here •  Rp / lD UCLA

  13. The real density is close to the geometric mean! UCLA

  14. Reason: collisions destroy orbiting An orbiting ion loses its angular momentum in a charge-exchange collision and is accelerated directly to probe. Thus, the collected current is larger than predicted, and the apparent density is higher than it actually is. UCLA

  15. This collisional effect has been verified Sternovsky, Robertson, and Lampe, Phys. Plasmas 10, 300 (2003). Sternovsky, Robertson, and Lampe, J. Appl. Phys. 94, 1374 (2003). Rp/lD = 0.05 Rp/lD = 0.49 Rp/lD = 0.26 The extra ion current due to collisions is calculated and added to the OML current. The result agrees with measurements only for very low density (< 108 cm-3). The theory is incomplete because the loss of orbiting ions is not accounted for. Also, there is no easy computer program. UCLA

  16. Summary: how to measure density with Isat High density, large probe: use Bohm current as if plane probe. Ii does not really saturate, so must extrapolate to floating potential. Intermediate Rp / lD: Use BRL and ABR theories and take the geometric mean. Small probe, low density: Use OML theory and correct for collisions. Upshot: Design very thin probes so that OML applies. There will still be corrections needed for collisions. UCLA

  17. Problems in partially ionized, RF plasmas • Ion currents are not as predicted • Electron currents are distorted by RF • The dc plasma potential is not fixed UCLA

  18. Introduction: RF distortion of I-V trace - 1 UCLA

  19. Solution: RF compensation circuit* * V.A. Godyak, R.B. Piejak, and B.M. Alexandrovich, Plasma Sources Sci. Technol. 1, 36 (19920. I.D. Sudit and F.F. Chen, RF compensated probes for high-density discharges, Plasma Sources Sci. Technol. 3, 162 (1994) UCLA

  20. Self-resonance of choke chains To get high impedance, self-resonance of chokes must be used. Chokes must be individually chosen because of manufacturing variations. UCLA

  21. A large compensation electrode helps UCLA

  22. Ideal OML curve What is the sheath capacitance as Vs oscillates? A small RF oscillation will bring the probe from the Child-Langmuir sheath to the Debye sheath to electron saturation UCLA

  23. Sheath capacitance: exact vs. C-L This is an extension of the work by Godyak: V.A. Godyak and N. Sternberg, Phys. Rev. A 42, 2299 (1990) V.A. Godyak and N. Sternberg, Proc. 20th ICPIG, Barga, Italy, 1991, p. 661 UCLA

  24. Variation of Csh during an RF cycle Large probe, which draws enough current to affect Vs. These curves will give rise to harmonics! A normal small probe, which goes into electron saturation. Cylindrical effects will smooth over the dip. UCLA

  25. Problems in partially ionized, RF plasmas • Ion currents are not as predicted • Electron currents are distorted by RF • The dc plasma potential is not fixed UCLA

  26. Ideal OML curve Peculiar I-V curves: not caused by RF UCLA

  27. Potential pulling by probe Curves taken with two probes, slowly, point by point UCLA

  28. 1.9 MHz, 60-100W, 3-10 mTorr Ar Apparatus: anodized walls, floating top plate Ceramic shaft UCLA

  29. Direct verification of potential pulling UCLA

  30. Correcting for Vf shift gives better I-V curve UCLA

  31. Slow drift of probe currents: ions A scan takes 2-3 sec (200 points), and ~3 sec between scans. The time constant is very long. UCLA

  32. Slow drift of probe currents: electrons The drift direction depends on the parking voltage between scans. The drift can continue for >10 sec. UCLA

  33. Reason: the walls are charged through the probe • The only connection to ground is through the probe. • The plasma potential has to follow Vp. • Hence the capacitance of the insulating layer has to be charged. CV = Q = I*t, t = CV/ I C = R0Aw/d, Aw = 0.44 m, R ~ 3, d ~ 1 m C ~ 10 F, V ~ 100 V, Ie ~ 2 mA  t ~ 0.5 sec This is the right order of magnitude. Slower drifts may be due to small leaks in the insulation. UCLA

  34. Insertion of grounding plate close to probe UCLA

  35. Grounding plate reduces change in Vf High pressure (9.7 mTorr) Low pressure (2.7 mTorr) UCLA

  36. But the I-V curves are about the same UCLA

  37. Compare with ideal OML curve The ion part fits well. The electron part, after correcting for the Vf shift, fits the exponential region better, but still fails at saturation. The remaining discrepancy must be due to inadequate RF compensation. UCLA

  38. Applying +100V to probe suddenly SOURCE e + + + + + e + WALL e + + + e + + e Vs ~ Vs0 e e e There is an initial transient, but a normal electron sheath at electron saturation should come to equilibrium in several ion plasma periods (<< 1 msec). UCLA

  39. e i i e e With a grounding plane, how can a probe affect Vs? Normally, the probe current Ie is balanced by a slight adjustment of the electron current to the walls, Iew, via a small change in sheath drop. Since Iew = Iiw, Vs should not change detectably if Ie << Iiw. UCLA

  40. Let’s work out the numbers Bohm current density: Ii = 0.5 neAwcs ( n = 2 x 1010 cm3, KTe = 1.6 eV) Ion current to grounding plate (25 cm2) » 8.5 mA Electron saturation current at +100V = 25 mA (measured) (Same order of magnitude, within variations.) Thus, at high Vp, ion loss is too small to balance electron loss. BUT: Vs changes well before Ie reaches 25 mA The ion flux to ground may be less than Bohm. UCLA

  41. If no grounding plate, how long does it take for the ions to redistribute themselves? If the probe draws excess electrons at the center, an ambipolar field will develop to drive ions faster to the wall. The density profile n(r) will change from essentially uniform to peaked. The diffusion equation for a nearly spherical chamber is where D = Da, the ambipolar diffusion coefficient. The solution is The time constant for the lowest radial mode j = 1 is then UCLA

  42. Time to change from uniform to peaked profile Thus, the time required for the ions to adjust to a new equilibrium is only about 1 msec or less. UCLA

  43. A measured radial density profile UCLA

  44. Conclusion: timing is critical • The dwell time must be long enough for the sheath to come into • equilibrium. This is several ion plasma periods (>100 nsec). • The total sweep time must be << 1 msec, or the plasma potential • will change. • With very slow sweeps, Vs will change and must be monitored. Even a DC, point-by-point measured I-V curve may not be correct. UCLA

  45. Too fast a scan: sheath not in equilibrium UCLA

  46. Hence we must use a dc reference electrode. HERE UCLA

More Related