1 / 8

Hillside Development Permit 09-38

Planning Commission: 01/12/10. Hillside Development Permit 09-38. Deuk Lee / Oh’s Design & Development 5209 Diamond Point Road. Location and Proposal. Hillside Development Permit Slope Factor: 17.34% 30% Roof Removal = New Single-story House. Site Plan and Project Description.

sezja
Download Presentation

Hillside Development Permit 09-38

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Planning Commission: 01/12/10 Hillside Development Permit 09-38 Deuk Lee / Oh’s Design & Development 5209 Diamond Point Road

  2. Location and Proposal Hillside Development Permit Slope Factor: 17.34% 30% Roof Removal = New Single-story House

  3. Site Plan and Project Description (E) 1st Floor: 2,211 S.F. Total Floor Area: 3,831 S.F. (E) Garage: 422 S.F. Floor-Area-Ratio: 32.5% 1st Floor Addition: 1,198 S.F. Lot area: 11,790 S.F. Front Porch: 36 S.F. (does not count towards FA) Trellis Patio: 140 S.F. (does not count towards FA)

  4. Setback Encroachment Diagram

  5. Front and Rear Elevations Front Rear

  6. Side Elevations North South

  7. Cross Sections Added Condition: The attic roof shall be supported by trusses with the bottom chord less than 6 feet above the attic’s finished floor level. The trusses shall be spaced no farther than 4 feet on center.

  8. Recommendations: Based on the previous discussion, staff recommends that the Hillside Development Permit BE APPROVED, subject to the conditions listed in Exhibit “A”, attached to the resolution.

More Related