1 / 8

Cryomodule prototype

Cryomodule prototype. Yun He, Dan Sabol, Joe Conway On behalf of Matthias Liepe, Eric Smith, James Sears, Peter Quigley, Tim O’Connell, Ralf Eichhorn, Georg Hoffstaetter. Differences of Prototype Module from Linac Module. Prototype cryomodule. Cryo-feed can. End cap.

ruthmcconnell
Download Presentation

Cryomodule prototype

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Cryomodule prototype Yun He, Dan Sabol, Joe Conway On behalf of Matthias Liepe, Eric Smith, James Sears, Peter Quigley, Tim O’Connell, Ralf Eichhorn, Georg Hoffstaetter

  2. Differences of Prototype Module from Linac Module Prototype cryomodule Cryo-feed can End cap Flange-to-flange: 10.4 m Yun HE, MLC External Review

  3. Cryo-feed can Cryo feed head from heat exchanger, to feed cryogen to module Two lines to be blanked off HGRP and six lines – 1.8K -- 5K (supply, return) -- 40-80K (delivery, supply, return) • Shield end section mounted to main shield • End plates in two halves Yun HE, MLC External Review

  4. Cooling pipes Flanges/elbows to connect to cryo-feed head are pre-welded Yun HE, MLC External Review

  5. End cap • Piping blanked off • HGRP • 5K (supply & return) • 1.8 K • 40 K return • 40K delivery & supply lines connected by ½” tubing Port for access to tuner/GV Manual gate valve to be supported with G10 to HGRP, w/ key alignment • 40K shield curved inwards • Manual gate valve intercepted @80K Yun HE, MLC External Review

  6. Cooling of 2nd half of HGRP for prototype module • For prototype, a second connection between HGRP and 2K-2 phase at far end provides cooling of the second half section of HGRP • A bellows section at very end on 2K-2 phase • This applies to the last cryomodule in the linac string Pipe support Yun HE, MLC External Review

  7. Beamline warm-cold transitions • Warm-cold transitions, wall 1.65mm • Will have sliding joints on beamline outside module to accommodate beamline shifts at cold Gate valves intercepted @80K Replacement of SC magnets • Bellows section connects beampipe to end flange of can • allows for displacements of beamline at cold • Vertical: 1.2 mm • Longitudinal: 8 mm Yun HE, MLC External Review

  8. Wire position monitor • For prototype module only, to monitor relative displacement between the wire and cold mass • Mounted on end cap flanges (room temperature), thus the wire position is not influenced by cool-down Heat treated CuBe wire (ɸ0.5 mm) is stretched parallel to the beam axis providing a position reference • Sensors attached to end flange of cavity LHe vessel • Two sensors for 1st, 3rd, 5th cavities to monitor pitch displacements • One sensor for each of the rest three cavities A WPM sensor consists of four striplines spaced 90° apart Yun HE, MLC External Review

More Related