1 / 20

Theory Review

Theory Review. Oxy Fuel and SMAW. Oxy/Fuel. What gas provides the hottest flame when burned with oxygen? a . Natural gas b . P ropane c . Acetylene d . MAPP . Propane 4,530 °F (2,500 °C) Natural Gas (methane) 5,190 °F (2,865 °C)

raquel
Download Presentation

Theory Review

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Theory Review Oxy Fuel and SMAW

  2. Oxy/Fuel • What gas provides the hottest flame when burned with oxygen? a. Natural gas b. Propane c. Acetylene d. MAPP

  3. Propane • 4,530 °F(2,500 °C) • Natural Gas (methane) • 5,190 °F(2,865 °C) • MAPP - methylacetylene-propadienepropane • 5,300 °F (2,925 °C) • Acetylene/Oxygen • 5,700 - 6,330 °F(3,150 - 3,500 °C)

  4. 2. What flame type has excess oxygen? a. reducing b. neutral c. carburizing d. oxidizing

  5. 3. What is the maximum safe working pressure when using acetylene?a. 15 lbs b. 10 lbs c. 20 lbs d. 30 lbs

  6. DANGER-WARNING

  7. 4. Oxygen hoses are a. blue b. green c. red d. red and green striped

  8. 5. Devices that prevent the gases from mixing in the hoses are called a. back stoppers b. one way valves c. reverse flow check valves d. gas valves

  9. 6. The gap created by the cut is called the a. gap b. width c. kerf d. opening

  10. 7. The vertical lines on the face of the cut are called a. drag lines b. cutting lines c. sever lines d. heat lines

  11. Tip Sizes

  12. 8. Oxyfueltorches can cut a. carbon steel b. aluminum c. copper nickel d. all of the above

  13. 9. The flames used to bring the metal up to cut- ting temperature are called the a. warming flames b. cutting flames c. preheat flames d. reducing flames

  14. 10. A condition that exists when the flame burns back in the torch is called a a. burnback b. explosion c. reverse flow d. flashback

  15. SMAW 11. For an E-7018 electrode the 70 stands for the a. tensile strength times 10,000 lbs b. flux coating c. position the electrode can be used in d. core wire composition

  16. 12. The SMAW process uses what type of power supply? a. constant potential b. constant voltage c. high voltage d. constant current

  17. 13. An E-11018 electrode a. is a low hydrogen electrode b. has a tensile strength of 110,000 PSI c. can be used in all positions d. is all of the above

More Related