1 / 11

Anglicky v odborných předmětech "Support of teaching technical subjects in English “

Anglicky v odborných předmětech "Support of teaching technical subjects in English “. Tutorial : Engineering technology Topic : Hot forming Prepared by : Ing. Elena Nová. Projekt Anglicky v odborných předmětech, CZ.1.07/1.3.09/04.0002

olaf
Download Presentation

Anglicky v odborných předmětech "Support of teaching technical subjects in English “

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Anglicky v odborných předmětech"Support ofteachingtechnicalsubjects in English“ Tutorial: Engineering technology Topic: Hot forming Prepared by: Ing. Elena Nová Projekt Anglicky v odborných předmětech, CZ.1.07/1.3.09/04.0002 je spolufinancován Evropským sociálním fondem a státním rozpočtem České republiky.

  2. Hot forming

  3. Hot forming Recrystallization temperature Is a temperature at which starts regeneration of deformed grains originated at cold forming without lattice change. Division of forging technologies according to temperature is: 1.Cold forging (under recrystallization temperature when temperature is under 30% under melting point of forged material)

  4. Hot forming 2. Forming is above recrystallization temperature, recrystallization speed is so high that hardening disappear already during forming or immediately after.

  5. Hot forming Hot forming temperature is above 70% of the formed material melting point. Material is not strengthened, the actual forming require force 10x smaller than needed for cold forming. At higher temperatures is deformation accompanied by recovery and recrystallization.

  6. Hot forming • At hot forming a texture might or might not be initiated but surface is not of good quality due to scales, furthermore grain become coarser, which can influence next technological operations. • Whole process is time consuming and expensive, on the other side bubbles, tears, etc. are eliminated.

  7. Hot forming • Undesired effect of Hot Forming is formation of a ‘fibrous structure’. • Fibrous structure is impossible to change by heat treatment or subsequent forming. • Fibrous structure influence mechanical properties and anisotropy. • Is initiated by impurities on grain surface.

  8. Hot forming • Influence of grain size on cut quality: • Small grain Large grain

  9. Hot forming • At recovery starts drop of internal stress. Recovery speed is dependent on temperature and time. • Grain size dependence on time

  10. Used literature • strojirenstvi.studentske.cz/2008/10/kontrola-vady-odlitk.html • /www.ksp.tul.cz/cz/kpt/obsah/vyuka/skripta_tkp/sekce/01.htm

More Related