1 / 3

Software development

Software development. SySal modules under test: - FlexStage5 (new module): digital IO port interface - VertigoScan 6.1 (modified): added calls to oil distribution - TecnoCutPlateChanger (new module): provide - IO Port monitor

noura
Download Presentation

Software development

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Software development SySal modules under test: - FlexStage5 (new module): digital IO port interface - VertigoScan 6.1 (modified): added calls to oil distribution • - TecnoCutPlateChanger(new module): provide • - IO Port monitor • - basic operations: go to load position , lock plate, unlock plate, start,… • - Full macros: Load Plate, Unload Plate, Dispense Oil • Development version installed at LNGS and Bologna G.Sirri - INFN Bologna

  2. Functional test 2 Plate Changers installed in the Bologna Scanning Lab:- PC1: setup for glued emulsions - PC2: setup for no glued emulsions Software setup:Standard ScanServer (same as any other microscope) driven by a modified client to just load/unload emulsion plates. Mark finding and measurements are skipped. TEST of full brick load/unload: ok for both plate changersPC1 (glued emulsions) : very smoothPC2 (no glued emulsions): ok using frosted glass window ok using normal glass window with an additional external system to provide high pressure (8 bar) compressed air G.Sirri - INFN Bologna

  3. Measure tests Brick scanback driven by the standard SySalscanback driver Setup:PC2 (no glued emulsions) “manual oil dispenser” Very preliminary result: fill factor as expected but several problems occured due to oil - the glass window dirty (possible problem for vacuum, lateral mark finding, …) - some failures during the detaching of dirty emulsions from some surfaces of the plate changer - emulsions and separators must be cleaned manually before being used again These issues should be fixed dry objective ? G.Sirri - INFN Bologna

More Related