html5-img
1 / 25

Date: 2011-07-19

Improving the Case for Wireless LAN Transmit Power Control— including to better service Mobile Telephones?. Date: 2011-07-19. Authors:. Abstract. Test results are presented that show significant reduction of mobile phone battery current when WiFi transmit power output is reduced.

noah-velasquez
Download Presentation

Date: 2011-07-19

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Improving the Case forWireless LAN Transmit Power Control— including to better service Mobile Telephones? Date: 2011-07-19 Authors: Lawrence H. Zuckerman, National Semiconductor Corp.

  2. Abstract Test results are presented that show significant reduction of mobile phone battery current when WiFi transmit power output is reduced. A 1994 802.11 submission on elaborate clear channel assessment is resurrected, wherein it is suggested that with considerable added network intelligence that includes definitive RF output control would increase throughput. Lawrence H. Zuckerman, National Semiconductor Corp.

  3. Introduction • There has been considerable discussion during the past five or so years as to whether or not a definitive transmit power control algorithm should be part of the 802.11 standards in general, not just in the cases where they are mandated by regulations. • Given the evolution of wireless LANs to Access Points, as opposed to Ad-hoc groups, such power control may resemble that found in the cellular networks, where it was first mandated by the technical requirements of DSSS implementation (“CDMA”, etc.) • Thus far, proponents of definitive TPC failed to show sufficient benefit to network throughput or for the users in other ways. Lawrence H. Zuckerman, National Semiconductor Corp.

  4. Large File Uploading from Phones—How much? • File down-loading normally primary use of phone. Requires only minor use of PA—power control not warranted. Major uses: Reading articles & promotional materials; watching videos • Large file up-loading varies with user. Primary uses are self-produced or relayed picture sets or videos. Possibly revised social networking pages or work products such as slide presentations. Present or future uses may include video games. • Need statistics on how much large file uploading is used. • Need statistics on sizes of large files being uploaded. • Could use JPEG & MPEG file sizes • Nothing known about present or future on-line/interactive video games Lawrence H. Zuckerman, National Semiconductor Corp.

  5. Availability of WiFi Access Points • What is probability that user is at Access Point when he has data to upload? • Studies have indicated that on the average, users are in some hot spot 70% of their waking hours, that they spend 2 hours in each hot spot & return to some hot spot in 40 minutes. • Building more hotspots is much less costly than increasing 4G capacity. • How long can/will user wait to be at an Access Point? Often, data does not need to be sent immediately. • What incentives can be presented to the user to wait for proximity to Access Point? • Costly 3/4G time vs. free or much lower cost AP time (already the case when traveling in foreign country). • Users know/will know that uploads are much quicker at APs Some information from this slide from Lee, Rhee, Lee, Chong, Yi—“Mobile Data Offloading: How Much Can WiFi Deliver?” Lawrence H. Zuckerman, National Semiconductor Corp.

  6. Basic Reasons Why WiFi Use Results in Reduced Battery drain • WiFi data rate is much higher than 3/4G—54 Mb/Sec vs 22 Mb/sec upstream; so transmitter is running for a shorter period of time to send the same information. • WiFi Access Point (AP) is tens to hundreds of feet away from phone instead of thousands of feet away to miles for a cell site; so lower transmit power is needed for similar data rate. • Path loss of 85 dB 64 feet from APs supports use of 802.11g service by phones. • Path loss to cellular antenna sites are normally well over 100 dB. Lawrence H. Zuckerman, National Semiconductor Corp.

  7. Opportunities to Reduce PowerWhen WiFi is in Use • To reduce interference to adjacent access points, the access points could reduce transmit output power and order the users (“stations”) to do the same when it can be done without data loss. • Based upon measured signal strength of access points (APs) & knowledge of the access point’s effective radiated power (data field provided by 802.11v), the phone can unilaterally reduce its transmit output power without suffering data loss. • -67 dBm needed for 802.11g, exists at typical AP 64 ft from (phone) with ERP of +18 dBm. • Assume PA output is +22 dBm and antenna gain is -4 dB, to radiate +18 dBm. • 20 ft from AP, only about +10 dBm will be needed from amplifier Lawrence H. Zuckerman, National Semiconductor Corp.

  8. Assistance Requested from Mobile Phone Makers • The following statistics are needed: • Quantify present and future time usage of large files being uploaded from phones. • Quantify the sizes of these large files. Lawrence H. Zuckerman, National Semiconductor Corp.

  9. DC-DC Converter-Augmented RF Power Amplifier in Mobile Phone 4.3 V fully charged 3.8V main life Voltage conversion Non Dissipative Battery DC-DC Converter Final Amplifier RF in RF out Lawrence H. Zuckerman, National Semiconductor Corp.

  10. 3.8V Battery Current Reduction w/DC-DCConverter on RF PA, 802.11g, 54 Mb/S OFDM Lawrence H. Zuckerman, National Semiconductor Corp.

  11. 3.8V Battery Current Reduction w/DC-DCConverter on RF PA, 802.11g, 54 Mb/S OFDM Lawrence H. Zuckerman, National Semiconductor Corp.

  12. Reduction of Battery Current w/Distance from Access Point & Needed RF Output Power • Even at power output of +22 dBm, needed for 802.11g at 64 feet from Access Point, application of DC-DC converter reduces Ibatt by 120 mA, 444 mW (44%) • For reduction of power output to +10 dBm, allowable if 20 feet from Access Point, PA itself can reduce Ibatt from 151.2 mA to 40.7 mA by going into medium power mode • Using DC-DC Converter, there is an additional reduction of 22.8 mA, 84.4 mW (44%). • A WiFi PA device not configured to use a DC-DC converter draws 225 mA while delivering +22 dBm (the maximum it can deliver while meeting all 802.11 standards) and 95 mA while delivering +10 dBm Lawrence H. Zuckerman, National Semiconductor Corp.

  13. Reduction of Battery Current w/Distance from Access Point & Needed RF Output Power 64 feet 20 Lawrence H. Zuckerman, National Semiconductor Corp.

  14. Former address redacted Lawrence H. Zuckerman, National Semiconductor Corp.

  15. Summary of Advanced CCA Method in 94/132 Further Topics in Submission • Careful set of definitions of terms used • Comments on existing CCA recommendations • The proposed elaborate CCA Method • Estimation of network efficiency improvement • Implementation details and issues Lawrence H. Zuckerman, National Semiconductor Corp.

  16. The fundamental problem of present CCA is that the Subject Node can be cognizant of the interference conditions only at his location, yet an accurate CCA can be performed only if one knows the conditions at his Recipient’s location, the Incumbant’s location, and the location of Incumbant’s Recipient. Fundamental Problem of Clear Channel Assessment as it is now done New Term Coined: TDA instead of CCA It is useful to define a new term. In radio work on uncontrolled bands there is, in general, no clear channel; so Clear-Channel Assessment is really a misnomer. The new process uses a complicated formula to determine whether or not to defer. Therefore, the new name for this process is TRANSMISSION DEFERRAL ASSESSMENT or “TDA”. Lawrence H. Zuckerman, National Semiconductor Corp.

  17. Basic TDA Idea (1) First, it is necessary to display Effective Radiated Power (“ERP”) in every Fragment preamble, with a resolution of 1 dB. If the overall range is from 1 mW up to 1.6 W, only 5 bits are required. Variable transmit ERP on a per-packet basis would provide additional throughput improvement. 3 dB steps would be ideal, but any ERP variation would be helpful. By keeping (initiating and updating) a (“Chart”) of transmitted and received ERP for every readable Node, each Node would have rough distance data (i.e. could draw concentric circles representing the distances). More precisely and importantly, each Node would “know” the path loss between himself and every other Node. Lawrence H. Zuckerman, National Semiconductor Corp.

  18. Basic TDA Idea (2) Secondly, in some prescribed manner, each Node periodically transmits its Chart; so that every Node ends up with all the Charts. The system determining when a Node includes his Chart (or even on occasion another Node’s Chart, to eliminate the Hidden Node effect) as a field, is governed by many factors, such as network loading and perceived changes to his Chart. During periods of light loading, the Charts can be broadcast via special network maintenance Transmissions; so they are ready for efficient operation when payload Packets/Fragments are ready. Lawrence H. Zuckerman, National Semiconductor Corp.

  19. The Subject Node does not need to draw a map; it has the exact information it needs to perform TDA: • Incumbent Node’s ID, ERP, and Recipient’s ID, from Incumbent Node’s preamble; • Path loss between the Incumbent Node and Recipient; • Path loss between himself and his own Recipient; • Path loss between himself and the Incumbent Node’s Recipient; • Path loss between the Incumbent Node and Subject’s Recipient. • All Subject has to do to begin a Transmission is calculate the lowest ERP which makes him 15 dB or more stronger than the Incumbent Node at his own Recipient’s location (and strong enough to be decoded by Same) and 15 dB or more weaker than the Occupying Node at the latter’s Recipient. If no such ERP is available to Subject, he Defers! • The method works equally well for 3-dimensional geometry. Basic TDA Idea (3) Lawrence H. Zuckerman, National Semiconductor Corp.

  20. The method will increase network throughput, because it will decrease the probabilities of both False Deferrals and Ruined Transmissions. Owing to the available information, there is a greater probability of finding a high enough ERP; as every Transmission, including the ones initiated with no Activity, can be made using minimal ERP. Lawrence H. Zuckerman, National Semiconductor Corp.

  21. Lawrence H. Zuckerman, National Semiconductor Corp.

  22. Lawrence H. Zuckerman, National Semiconductor Corp.

  23. Fortunate Results of this CCA (“TDA”) Method • Hidden transmitter effects are mitigated • For many occasions, a transmission can be made without interference, even while another transmission is in progress. • Method works best with Transmit Power Control Lawrence H. Zuckerman, National Semiconductor Corp.

  24. Further Work Needed/Requested • Study and critique Submission P802.11-94/132 & 132R1 • Update the calculations to account for present-day modulation and symbol rates. • Complete and update the “Estimation of Network Efficiency Improvement” that starts on Page 8 and goes to Page 15. • Invent additional/complementary ways to use intelligent computing power to make the access points and stations work together to regulate transmitter output power and increase network throughput. Lawrence H. Zuckerman, National Semiconductor Corp.

  25. References • Zuckerman; IEEE 802.11-94/132 & /132r1 • Backes, Kwak, Durand, Qi, Ashley 802.11-07/0695 Lawrence H. Zuckerman, National Semiconductor Corp.

More Related