1 / 5

Vacuum chuck for probe station

Vacuum chuck for probe station. contacts: Howard Wieman hhwieman@lbl.gov work: 510 495-2473 cell: 631 431-8236 Eric Anderssen ECAnderssen@lbl.gov 510 495-2821.

levia
Download Presentation

Vacuum chuck for probe station

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Vacuum chuck for probe station contacts: Howard Wieman hhwieman@lbl.gov work: 510 495-2473 cell: 631 431-8236 Eric Anderssen ECAnderssen@lbl.gov 510 495-2821

  2. This vacuum chuck will be used to hold and accurately locate 2 mil thick silicon chips in a probe station. It consists of two aluminum plates bonded to a SLA manufactured vacuum manifold. This is a request for the machined aluminum parts. The parts are modeled with SolidWorks 2009 Top Assembly: “vc probe assembly.SLDASM”

  3. machining tasks

  4. “vc probe top.SLDPRT” tolerance: top and bottom surface flat and parallel to 2 mil surface finish? tolerance: locating edges for the silicon chips – relative location with respect to each other good to 1 mil

  5. “vc probe suction plate.SLDPRT” tolerance: top and bottom surface flat and parallel to 2 mil tolerance: capture lip radius -0 + 4 mil surface specification ? must suck down to a metal vacuum plate

More Related